A CFD Analysis of Flow through a High-Pressure Natural Gas Pipeline with an Undeformed and Deformed Orifice Plate
نویسندگان
چکیده
This work aims to present a numerical analysis of the natural gas which flows through a high-pressure pipeline and an orifice plate, through the use of CFD methods. The paper contains CFD calculations for the flow of natural gas in a pipe with different geometry used for the orifice plates. One of them has a standard geometry and a shape without any deformation and the other is deformed by the action of the pressure differential. It shows the behavior of natural gas in a pipeline using the velocity profiles and pressure fields of the gas in both models with their differences. The entire research is based on the elimination of any inaccuracy which should appear in the flow of the natural gas measured in the highpressure pipelines of the gas industry and which is currently not given in the relevant standard. Keywords—Orifice plate, high-pressure pipeline, natural gas, CFD analysis.
منابع مشابه
The Indication of Two-Phase Flow Pattern and Slug Characteristics in a Pipeline Using CFD Method
Multiphase flows are commonly encountered in oil and gas industries. The transport of multiphase flow causes the formation of slug, the increase of pressure drop and the possibility of phase changes therefore, a set of simulation runs was performed to predict flow regimes in a horizontal pipeline, and the results were compared with the Baker chart. The effects of small downward inclinations of ...
متن کاملExperimental values for adjusting an automatic control valve in gas pipeline transportation
When a natural gas pipeline ruptures, the adjacent automatic line control valves (ALCVs) should close quickly to prevent leakage or explosion. The differential pressure set point (DPS) at each valve location is the main criteria for value setting in ALCV action. If the DPS is not properly adjusted, the ALCV may mistakenly close or it may not take any action at proper time. This study focused on...
متن کاملGas Flow Metering Using the PSO Optimized Interval Type- 2 Fuzzy Neural Network
Orifice flow meter is one of the most common devices in industry which is used for measuring the gas flow. This system includes an orifice plate, temperature and pressure transmitters, and a flow computer. The flow computer is used for collecting information related to temperature, pressure, and their differences under various conditions. Also the flow computer can calculate the flow rate of ga...
متن کاملExperimental Modeling of a Long Orifice-type Restrictor of High Speed Turbine Hybrid Bearing
To overcome the space limit of orifice-type and capillary restrictors in hybrid bearings, a kind of atypical long orifice-type restrictor is proposed and its experimental model is established. Through the analysis of the structure and flow rate of orifice-type restrictor and capillary restrictor, a long orifice-type restrictor and a feasible experimental modeling method are presented by use of ...
متن کاملEffect of a ring type barrier and rotational speed on leakage flow of gas turbine brush seal
This paper investigates the effect of inserting a ring type barrier on leakage flow of brush seals with different bristles clearances (the distance between bristle pack tip and rotor surface). The ring is placed on both upstream and downstream sides of the bristles. An axisymmetric CFD model is employed to calculate radial pressure distribution along backing plate, axial pressure variation on r...
متن کامل