Adaptive Measurement of Power System Currents, Voltages and Impedances in Off-nominal Frequency Cond - Instrumentation and Measurement Technology Conference, 1999. IMTC/99. Proceedings of the 16th IEEE

نویسنده

  • J. Szafran
چکیده

In the paper the problem of basic power system electric quantities (current, voltage magnitudes, power and impedance) measurement in off-nominal frequency conditions is considered under assumption thal the quantities are calculated from orthogonal components of input current and voltage phasors which are obtained by use of the nonrecursive digital Jilters. Adaptive algorithms which make the measurement insensitive to wide range freq~e~vlcy changes of the input signal,^ are presented. The adaptive features of the algorithm,^ are obtained by use of the frequency measuring algorithm and mod$cation of orthogonal Jilters coeficients and data window length. Sample results of simulation studies which show the algorithm performance are presented and discussed in the paper.

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Employing dual frequency phase sensitive demodulation technique to improve the accuracy of voltage measurement in magnetic induction tomography and designing a labratoary prototype

Magnetic induction tomography (MIT) is a promising modality for noninvasive imaging due to its contactless technology. Being a non-contact safe imaging technique, MIT has been an appropriate method in compare to other electrical tomography. In this imaging method, a primary magnetic field is applied by excitation coils to induce eddy currents in the material to be studied and a secondary magnet...

متن کامل

A New Noise Parameter Measurement Method For Microwave Devices - Instrumentation and Measurement Technology Conference, 1996. IMTC-96. Conference Proceeedings. 'Qu

This paper proposes a new method fo r noise parameter measurement of microwave devices. Instead of measuring the noise figure, the optimum source impedance r o p t is determined by measuring the noise powers corresponding to cold impedances, then the minimum noise figure Fmn ( 0 r minimum effective noise temperature T,,,) and noise conductance Gn are determined by connecting a calibrated hot no...

متن کامل

Presenting a New Method Based on Branch Placement for Optimal Placement of Phasor Measurement Units

In this paper, a new method based on branch placement for the optimal positioning of Phasor Measurement Units (PMUs) in power systems is proposed. In this method, the PMUs are in type of single-channel and are installed at the beginning of the branches. Therefore, they are able to measure the bus voltages. Also, the installation of the PMUs on the branches increases the security of observabilit...

متن کامل

Improving the performance of UPQC under unbalanced and distortional load conditions: A new control method

This paper presents a new control method for a three-phase four-wire Unified Power Quality Conditioner (UPQC) to deal with the problems of power quality under distortional and unbalanced load conditions. The proposed control approach is the combination of instantaneous power theory and Synchronous Reference Frame (SRF) theory which is optimized by using a self-tuning filter (STF) and without us...

متن کامل

Grid Impedance Estimation Using Several Short-Term Low Power Signal Injections

In this paper, a signal processing method is proposed to estimate the low and high-frequency impedances of power systems using several short-term low power signal injections for a frequency range of 0-150 kHz. This frequency range is very important, and thusso it is considered in the analysis of power quality issues of smart grids. The impedance estimation is used in many power system applicati...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 1999