A 256mA 0.72V Ground Bounce Output Driver

نویسندگان

  • Pang-Cheng YU
  • Hun-Hsien CHANG
چکیده

A new output driver design called modified asymmetrical slew rate (MASR) output driver was proposed to reduce the simultaneous switching noise without sacrificing switching speed, for high speed and heavy loading applications. The driving capability of the output driver was designed to sink/source 64mA current @ VOL/VOH = 0.4V/4.6V, with 66 pF and 50Ω loading. When four drivers switch simultaneously, the ground bounce was design to be less than 0.8V. The performances of the conventional, controlled slew rate (CSR), and MASR output drivers were analyzed by computer simulation. These three types of drivers were implemented with a 0.8μm CMOS process. The measured ground bounce of the conventional driver is 1.22V, while the ground bounce of the MASR driver is reduced to 0.72V. The propagation delays of the conventional and MASR drivers are the same. The performance of the MASR driver is better than that of the CSR driver in all aspects. key words: MASR, ground bounce, output driver

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Analysis and Optimization of Ground Bounce in Digital CMOS Circuits

of the ground bounce in digital CMOS circuits. First, an analytical method for calculating of the ground bounce is presented. The proposed method relies on accurate models of the short-channel MOS device and the chip-package interface parasitics. Next the effect of ground bounce on the buffer propagation delay and the optimum taper factor is discussed and a mathematical relationship for total p...

متن کامل

OF PACKAGE I / O LEAD ELECTRICAL PARASITICS FOR DIFFERENT PACKAGES Electrical Parameters Wire - bonding Package Type

This paper is concerned with the analysis and optimization of the ground bounce in digital CMOS circuits. First, an analytical method for calculating the ground bounce is presented. The proposed method relies on accurate models of the short-channel MOS device and the chip-package interface parasitics. Next the effect of ground bounce on the propagation delay and the optimum tapering factor of a...

متن کامل

An Isolated Off-Line High Power Factor Electrolytic Capacitor-Less LED Driver with Pulsating Output Current

One of the most efficient lighting technology is based on light-emitting diodes (LEDs). Common LED drivers with AC-input (50-60Hz) usually require a bulk electrolytic capacitor to decrease low-frequency ripple in the output. However, the critical element that limits the lifespan of the LED driver is the electrolytic capacitor. An isolated off-line LED driver is proposed in this paper, in which ...

متن کامل

Progress in the Research of Ground Bounce Removal for Landmine Detection with Ground Penetrating Radar

Downward looking ground penetrating radar (GPR) has been considered a viable technology for landmine detection. For such a GPR with the antennas positioned very close to the ground surface, the reflections from the ground surface, i.e., the ground bounce, are very strong and can completely dominate the weak returns from shallowly buried plastic mines. Hence, one of the key challenges of using G...

متن کامل

Path Delay Test in the Presence of Power Supply Noise, Ground Bounce and Crosstalk

As technology scales down, the effects of power supply noise and ground bounce are becoming significantly important. In the existing literature, it has been shown that excessive power supply noise can affect the path delay, while ground bounce is either neglected or assumed similar to power supply noise [1-2]. Our work performs a detailed study of combined and uncorrelated power supply noise an...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2000