Finite Element Analysis Based Design of Mobile Robot for Removing Plug Oil Well
نویسندگان
چکیده
In order to develop the mobile robot for removing the plug oil well, the robot was designed based on the wheeltype and leg-type robot mechanism. A well functioning prototype has been manufactured. To demonstrate the validity and the benefit of the mobile robot, supporting mechanism and guiding rod were chosen to design based on the FEM. The mathematical model of the supporting mechanism is established and the mechanical property is analyzed using the FEM. The deformation and stress of some components of the supporting mechanism and the guiding rod is investigated. The results show that the supporting mechanism and the guiding rod have excellent performance with little displacement and small stress under working condition. The strength and rigidity of supporting mechanism and the guiding rod are good enough to ensure the reliability of the whole robot mechanism.
منابع مشابه
Maximum Allowable Dynamic Load of Flexible 2-Link Mobile Manipulators Using Finite Element Approach
In this paper a general formulation for finding the maximum allowable dynamic load (MADL) of flexible link mobile manipulators is presented. The main constraints used for the algorithm presented are the actuator torque capacity and the limited error bound for the end-effector during motion on the given trajectory. The precision constraint is taken into account with two boundary lines in plane w...
متن کاملA Novel Multimode Mobile Robot with Adaptable Wheel Geometry for Maneuverability Improvement
In this paper, an innovative mobile platform is presented which is equipped by three new wheels. The core of the new idea is to establish a new design of rigid circular structure which can be implemented as a wheel by variable radius. The structure of wheel includes a circular pattern of a simple two-link mechanism assembled to obtain a wheel shape. Each wheel has two degrees of freedom. The fi...
متن کاملPrediction of Crack Initiation Direction for Inclined Crack Under Biaxial Loading by Finite Element Method
This paper presents a simple method based on strain energy density criterion to study the crack initiation angle by finite element method under biaxial loading condition. The crack surface relative displacement method is used to eliminate the calculation of the stress intensity factors which are normally required. The analysis is performed using higher order four node quadrilateral element. The...
متن کاملRobust Sliding Mode Controller for Trajectory Tracking and Attitude Control of a Nonholonomic Spherical Mobile Robot
Based on dynamic modeling, robust trajectory tracking control of attitude and position of a spherical mobile robot is proposed. In this paper, the spherical robot is composed of a spherical shell and three independent rotors which act as the inner driver mechanism. Owing to rolling without slipping assumption, the robot is subjected to two nonholonomic constraints. The state space representatio...
متن کاملA study on behavior of block pavement using 3D finite element method
Three dimensioned finite element analysis were conducted on concrete block paving. In order to verify the calculated results, an experimental case study was analyzed. Good agreement was observed between the measured and the calculated results. Based on the finite element analysis results and available failure models, comprehensive design charts were developed for port and industrial pavement wh...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
- JCP
دوره 8 شماره
صفحات -
تاریخ انتشار 2013