EMC’04/Sendai ELECTROMAGNETIC EMISSION FROM EDGE PLACED DIFFERENTIAL TRACES ON PRINTED CIRCUIT BOARD
نویسندگان
چکیده
Edge placement of a differential pair on the printed circuit board causes balance disruption, and resulting in electromagnetic (EM) emission. In this work, the emission from edge placed differential traces is numerically simulated and also measured. The simulation is based on the FDTD method. The field distribution is accurately snapped in the simulation and the emission characteristics are revealed. In the measurements, both the electric and magnetic fields are measured for several geometries. Finally, the common-mode inductance of edge placed differential pair is derived and the EM emission is further investigated.
منابع مشابه
Emi-emc Analysis of Printed Circuit Board Traces
This paper presents the Electromagnetic interference (EMI) and Electromagnetic compatibility (EMC) analysis of a Printed Circuit Board (PCB). The width of the differential pair trace of the PCB was varied and the emission values were measured and compared, demonstrating an improvement in radiated emissions when the width of the trace was decreased. The trace width of the PCB was increased from ...
متن کاملEMC’04/Sendai Control of Unintentional Electromagnetic Waves from Digital Circuits: Efficient EMC Modeling of Devices and PCBs
A research project has been carried out for the last five years, the subject of which is to develop effective methods to control electromagnetic noise radiation from digital electronic devices. Engineering approaches were chosen and some new modeling methods of electromagnetic phenomena around a printed circuit board are shortly described in relation to EMI subjects. Those results have been com...
متن کاملEMC’04/Sendai COUPLING OF OPEN AND SHIELDED TRACKS ON PRINTED CIRCUIT BOARDS
The DM-CM-DM coupling between tracks of a PCB and the CM circuit formed with a nearby cabinet panel is discussed based on measurements. A novel track shielding technique and its consequences for signal transport are presented; intentional partial shielding is discussed.
متن کاملDevelopment and Validation of a Microcontroller Model for EMC (PDF)
Models of integrated circuits (ICs) allow printed circuit board (PCB) developers to predict radiated and conducted emissions early in board development and allow IC manufactures insight into how to build their ICs better for electromagnetic compatibility (EMC). A model of the power delivery network, similar to the ICEM or LECCS model, was developed for a microcontroller running a typical progra...
متن کاملMaximum Radiated Emissions of Printed Circuit Board Using Analytical Methods
Received Jun 12, 2017 Revised Aug 20, 2017 Accepted Oct 26, 2017 The rapid progress of technology has imposed significant challenges on Printed Circuit Boards (PCB) designers. Once of those challenges is to satisfy the electromagnetic compatibility (EMC) compliance requirements. For that reason, EMC compliance must be considered earlier at the design stage for time and cost savings. Conventiona...
متن کامل