Interface Adhesion between 2D Materials and Elastomers Measured by Buckle Delaminations
نویسندگان
چکیده
C. J. Brennan, J. Nguyen, Prof. E. T. Yu Microelectronics Research Center and the Department of Electrical and Computer Engineering The University of Texas at Austin Austin , TX 78758 , USA Prof. N. Lu Center for Mechanics of Solids Structures and Materials Department of Aerospace Engineering and Engineering Mechanics Texas Materials Institute The University of Texas at Austin Austin , TX 78712 , USA E-mail: [email protected]
منابع مشابه
Buckle delamination on patterned substrates
Lithographic techniques applied to a substrate prior to film deposition can create areas of low interface adhesion surrounded by regions of high adhesion. If the film is under compression and if buckle delamination is nucleated, conditions can be controlled such that delaminations are confined to the patterned areas of low adhesion. When the area of low adhesion is a strip, the width of the str...
متن کاملBuckling delamination in compressed multilayers on curved substrates with accompanying ridge cracks
Residually compressed films and coatings are susceptible to buckle delamination. The buckles often have linear or telephone cord morphology. When the films are brittle, such buckles are susceptible to the formation of ridge cracks that extend along their length, terminating close to the propagating front. The ridge-cracked buckles are invariably straight-sided (not telephone cord) and differ in...
متن کاملMeasurement of adhesion between soft elastomers
The JKR (Johnson–Kendall–Roberts) method is widely used to measure the work of adhesion between soft materials. In this article, the JKR theory is summarized and three-dimensionless parameters are proposed to design a proper JKR experiment. The study of adhesion between two commonly used soft elastomers PDMS (Sylgard 184) and Ecofl ex 0300 are obtained with the measured pull-in and pull-off for...
متن کاملAdhesion between highly stretchable materials.
Recently developed high-speed ionic devices require adherent laminates of stretchable and dissimilar materials, such as gels and elastomers. Adhesion between stretchable and dissimilar materials also plays important roles in medicine, stretchable electronics, and soft robots. Here we develop a method to characterize adhesion between materials capable of large, elastic deformation. We apply the ...
متن کاملDelamination monitoring in CFRP laminated plates under noisy conditions using complex-wavelet 2D curvature mode shapes
Delamination monitoring in carbon fiber reinforced polymer (CFRP) laminated plates is crucial to ensure the integrity and safety of the structures that accommodate the plates. To identify delaminations in CFRP laminated plates, the two-dimensional (2D) curvature mode shape method is a prevailing method that features instant and simultaneous determination of the presence and location of the dela...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2015