Optimization of the Deposition Parameters of Thick Atmospheric Plasma Spray Coatings
نویسنده
چکیده
Plasma spray process is one of the most versatile thermal spray deposition processes. There are great number of parameters that influence the quality and characteristic of deposited coating and their values must be defined precisely for each type of coating and used equipment individually. A review of the technology developed for deposition of ferrous-based powder spray (Fe-1.3Cr-1.5Mn-1.2C0.3Ni (wt. %)) on flat Al-Si alloy substrate surfaces is presented in this paper. Also possible problems that may occur before and during the deposition process were pointed-out, as well as adequate solutions of those problems.
منابع مشابه
THE EFFECTS OF PLASMA SPRAY PARAMETERS ON THE MICROSTRUCTURE AND PHASE COMPOSITION OF THERMAL BARRIER COATINGS MADE BY SPPS PROCESS
In this paper the effect of plasma spray parameters, atomizing gas and substrate preheat temperature on microstructure and phase composition of YSZ coatings produced by SPPS process have been investigated. The experimental results showed that increasing the power of plasma, using hydrogen as the precursor atomizing gas and increasing substrate preheat temperature decrease the amount of non-pyro...
متن کاملEffect of morphology and nonbounded interface on dielectric properties of plasma sprayed BaTiO3 Coating
In this research, BaTiO3 thick deposit has been successfully sprayed by air plasma spray. The microstructure and dielectric properties of thick films were investigated by secondary electron microscopy (SEM) and LCR meter respectively. XRD measurement was carried out on plasma sprayed BaTiO3. The results illustrate differences in the crystal structure between plasma sprayed coatings and feed sto...
متن کاملOxidation resistance of the nanostructured YSZ coating on the IN-738 superalloy
Conventional and nanostructured YSZ coatings were deposited on the IN-738 Ni super alloy by the atmospheric plasma spray technique. The oxidation was measured at 1100°C in an atmospheric electrical furnace. According to the experimental results the nanostructured coatings showed a better oxidation resistance than the conventional ones. The improved oxidation resistance of the nanocoating could ...
متن کاملThermal Sprayed Coatings Used Against Corrosion and Corrosive Wear
Coatings have historically been developed to provide protection against corrosion and erosion that is to protect the material from chemical and physical interaction with its environment. Corrosion and wear problems are still of great relevance in a wide range of industrial applications and products as they result in the degradation and eventual failure of components and systems both in the proc...
متن کاملComparison between the SBF response of hydroxyapatite coatings deposited using both a plasma-spray and a novel co-incident micro-blasting technique J.N.Barry, D.P.Dowling
This paper reports on the response of hydroxyapatite (HA) coatings, fabricated using two deposition technologies, to immersion in simulated body fluid (SBF). The deposition methods used were: plasma spray, a commercial standard, and CoBlast, a novel low temperature microblast technique. In the case of the latter, HA coatings are deposited by simultaneous blasting HA and abrasive powders concent...
متن کامل