Two - input Two - output Laboratory - scale Temperature System Based on Peltier Modules ?
نویسندگان
چکیده
A laboratory-scale temperature system for Control and Automation courses is presented. The system is a coupled two-input two-output process which use peltier modules for temperature control. This paper describes the laboratory-scale system in details. A linear dynamic model of the thermoelectric cooler including the heat sink and the cooling-load heat exchanger is developed and experiments are shown which illustrate the use of the system.
منابع مشابه
Sensitivity analysis and parameters calculation of PV solar panel based on empirical data and two-diode circuit model
In this paper, a simple algorithm based on a two-diode circuit model of the solar cell is proposed for calculating different parameters of PV panels. The input parameters required for this algorithm are available from datasheets of the standard PV modules. The values of series and parallel resistances, as well as the recombination factor of Diode 2, are estimated through an iterative solution p...
متن کاملAn Investigation of Temperature Effects on Solar Photovoltaic Cells and Modules
The solar photovoltaic (PV) systems are facing serious problems due to unavoidable losses in their system, leads to more devation of output power from the input power level. This effect is known as a mismatch effect and is available in PV systems. Many losses are encountered in PV system and it is difficult to minimize such losses. In this paper, the influence of thermal effect on the solar PV ...
متن کاملDesign and analysis of a thermoelectric generator for a heavy-duty vehicle in real road test
Heavy duty vehicles have a great share on fossil fuel consumption and greenhouse gases in the world, while they waste two third of chemical energy of fuel. On the other hand, simplicity and long life of thermoelectric generators (TEGs) are considered more and more to convert thermal energy to electrical one. In this paper a TEG designed in the exhaust system of Renault Midlum 195 Dxi Engine. Th...
متن کاملMulti-objective optimization of two hybrid power generation systems for optimum selection of SOFC reactants heat exchangers mid-temperatures
Increasing efficiency and decreasing cost are the main purposes in the design of the power generation systems. In this study two hybrid systems: solid oxide fuel cell (SOFC)-gas turbine (GT) and SOFC-GT-steam turbine (ST); are considered. Increasing the SOFC input temperature causes thermodynamics improvement in the hybrid system operation. For this purpose, using two set of SOFC reactants heat...
متن کاملMulti-Stage DC-AC Converter Based on new DC-DC converter for energy conversion
This paper proposes a multi-stage power generation system suitable for renewable energy sources, which is composed of a DC-DC power converter and a three-phase inverter. The DC-DC power converter is a boost converter to convert the output voltage of the DC source into two voltage sources. The DC-DC converter has two switches operates like a continuous conduction mode. The input current of DC-DC...
متن کامل