Structural Evaluation of Control Configurations for Multivariable Nonlinear Processes
نویسنده
چکیده
-This paper addresses the problem of evaluation of alternative control configurations on the basis of structural characteristics of the process. Relative order is proposed as the main analysis tool for this purpose. Using tools from graph theory, it is shown that generic calculation of relative orders requires only structural information about the process. Relative order is interpreted as a structural measure of the initial sluggishness of the response, as well as a structural analog of dead time, which expresses fundamental structura1 limitations in the control quality. A matrix of relative orders of input/output pairs is introduced, which leads to a characterization of structural coupling among input and output process variables. On the basis of the above properties, general structural evaluation guidelines are proposed for alternative sets of manipulated inputs and alternative input/output pairs. The application of the theory is illustrated in the case of an evaporation unit, a chemical reactor and a network of heat exchangers.
منابع مشابه
Optimal Control of Nonlinear Multivariable Systems
This paper concerns a study on the optimal control for nonlinear systems. An appropriate alternative in order to alleviate the nonlinearity of a system is the exact linearization approach. In this fashion, the nonlinear system has been linearized using input-output feedback linearization (IOFL). Then, by utilizing the well developed optimal control theory of linear systems, the compensated ...
متن کاملFault-Tolerant Control of a Nonlinear Process with Input Constraints
A Fault-Tolerant Control (FTC) methodology has been presented for nonlinear processes being imposed by control input constraints. The proposed methodology uses a combination of Feedback Linearization and Model Predictive Control (FLMPC) schemes. The resulting constraints in the transformed process will be dependent on the actual evolving states, making their incorporation in the de...
متن کاملEvaluation of the Centre Manifold Method for Limit Cycle Calculations of a Nonlinear Structural Wing
In this study the centre manifold is applied for reduction and limit cycle calculation of a highly nonlinear structural aeroelastic wing. The limit cycle is arisen from structural nonlinearity due to the large deflection of the wing. Results obtained by different orders of centre manifolds are compared with those obtained by time marching method (fourth-order Runge-Kutta method). These comparis...
متن کاملEvaluation of Damage Distribution in Elements of Dual Frames
Researches show that the strength criterion is inadequate for design of structures against seismic loads. Since structures yield and experience plastic deformation under strong ground motion, considering structural damage with inelastic behavior may be a considerable criterion for design and control of the structures.In this paper, three steel structures with dual system consisting of intermedi...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2001