Plasma-initiated rehydrogenation of amorphous silicon to increase the temperature processing window of silicon heterojunction solar cells
نویسندگان
چکیده
The dehydrogenation of intrinsic hydrogenated amorphous silicon (a-Si:H) at temperatures above approximately 300 °C degrades its ability to passivate silicon wafer surfaces. This limits the temperature of post-passivation processing steps during the fabrication of advanced silicon heterojunction or silicon-based tandem solar cells. We demonstrate that a hydrogen plasma can rehydrogenate intrinsic a-Si:H passivation layers that have been dehydrogenated by annealing. The hydrogen plasma treatment fully restores the effective carrier lifetime to several milliseconds in textured crystalline silicon wafers coated with 8-nm-thick intrinsic a-Si:H layers after annealing at temperatures up to 450 °C. Plasma-initiated rehydrogenation also translates to complete solar cells: A silicon heterojunction solar cell subjected to annealing at 450 °C (following intrinsic a-Si:H deposition) had an open-circuit voltage of less than 600 mV, but an identical cell that received hydrogen plasma treatment reached a voltage over 710 mV and an efficiency over 19%.
منابع مشابه
Amorphous silicon oxide window layers for high-efficiency silicon heterojunction solar cells
Articles you may be interested in Optimized amorphous silicon oxide buffer layers for silicon heterojunction solar cells with microcrystalline silicon oxide contact layers Enhancing the efficiency of SnS solar cells via band-offset engineering with a zinc oxysulfide buffer layer Appl. Analysis of sub-stoichiometric hydrogenated silicon oxide films for surface passivation of crystalline silicon ...
متن کاملDevelopment of laser-fired contacts for amorphous silicon layers obtained by Hot-Wire CVD
In this work we study aluminium laser-fired contacts for intrinsic amorphous silicon layers deposited by Hot-Wire CVD. This structure could be used as an alternative low temperature back contact for rear passivated heterojunction solar cells. An infrared Nd:YAG laser (1064 nm) has been used to locally fire the aluminium through the thin amorphous silicon layers. Under optimized laser firing par...
متن کاملElectrical and Optical Properties on Nanocrystalline Si/SiO2 Superlattice for Solar Cell Emitters
In this study, we made the heterojunction solar cells on Si substrate by fabricating a nanocrystalline Si/SiO2 superlattice emitter structure. Amorphous silicon and silicon dioxide superlattice were prepared by rf Si sputtering and plasma oxidation, respectively. The deposited amorphous silicon was crystallized at high temperature. Microstructure studies by TEM show that amorphous silicon was c...
متن کاملValence band alignment and hole transport in amorphous/crystalline silicon heterojunction solar cells
To investigate the hole transport across amorphous/crystalline silicon heterojunctions, solar cells with varying band offsets were fabricated using amorphous silicon suboxide films. The suboxides enable good passivation if covered by a doped amorphous silicon layer. Increasing valence band offsets yield rising hole transport barriers and reduced device effciencies. Carrier transport by thermal ...
متن کاملProbing the Nature of Annealing Silicon Carbide Samples for Solar Cell
SiC powder preparation using Sol-Gel method. The size of nano-particles grows as the temperature exceeds 900° C. Size of probable agglomerations produced, is approximately less than 50nm. The surface is suitable to be used for dye solar cells. SiC emission occurs at wavelength area of 11.3μm or wave number area of 884.95 cm-1. In this paper probing the nature of annealed SiC samples in mixture,...
متن کامل