Effects of Baffle Configuration on Mixing in a T-Shaped Micro-Channel

نویسنده

  • Dong-Jin Kang
چکیده

A numerical study was performed for a T-shaped microchannel to enhance mixing performance through a baffle configuration. The mixing performance was analyzed in terms of the DOM (degree of mixing) and the pressure load between the two inlets and outlet. Four different baffle configurations were designed and simulated to determine how they affect the mixing performance of a T-shaped microchannel. Among the four baffle configurations, a cyclic configuration of baffles produced the best results. It exhibited the fastest growth in the DOM along the microchannel. The cyclic configuration means that four baffles are attached to four side walls of the channel in a cyclic order. The mixing improvement occurs in two ways. One is in the baffle region, when the cyclic configuration causes the fluid flow to rotate in the cross section, unlike other configurations. The other improvement is observed in the remaining outlet branch after the baffle region. This improvement is due to twisting and elongation of the boundary between two fluids. The baffle size and the interval between two consecutive baffles are shown to be optimized in terms of the DOM for a given condition.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Steam Reforming Integrated with Oxidation of Methanol in a Micro-Channel Reactor with Different Micro-Baffle Shapes

A micro-channel heat exchanger reactor with different micro-baffle shapes has been studied numerically. Governing equations were solved base on the finite volume method with FLUENT software. In upper section, oxidation reaction of methanol was occurred and in lower section, steam reforming of methanol was done. Two sections were separated with solid part which played as heat exchanger and trans...

متن کامل

Numerical Study on Low Reynolds Mixing ofT-Shaped Micro-Mixers with Obstacles

Micromixers are one of the most crucial components of Lab-On-a-Chip devices with the intention of mixing and dispersion of reagents like small molecules and particles. The challenge facing micromixers is typically insufficient mixing efficiency in basic designs, which results in longer microchannels. Therefore, it is desirable to increase mixing efficiency, in order to decrease mixing length, w...

متن کامل

Investigating Fluid Mixing in Electro-Osmotic Flow Through Passive Micro-Mixers Having Square and Triangle Barriers

Objective: In this article, a numerical study is conducted on mixing of two fluids in the liquid phase with two different concentrations of a chemical species in the electro-osmotic flow. Methods: The base liquid is an electrolyte which flows in a two-dimensional micro-channel having electrically charged walls. Lorentz electric force, which is used as stimulating flow factor, is created by appl...

متن کامل

Investigating Fluid Mixing in Electro-Osmotic Flow Through Passive Micro-Mixers Having Square and Triangle Barriers

Objective: In this article, a numerical study is conducted on mixing of two fluids in the liquid phase with two different concentrations of a chemical species in the electro-osmotic flow. Methods: The base liquid is an electrolyte which flows in a two-dimensional micro-channel having electrically charged walls. Lorentz electric force, which is used as stimulating flow factor, is created by appl...

متن کامل

Gas Mixing Simulation in a T-Shape Micro Channel Using The DSMC Method

Gas mixing in a T-shape micro mixer has been simulated using the Direct Simulation Monte Carlo (DSMC) method. It is considered that the adequate mixing occurs when the mass composition of the species, CO or N2, deviates below 1 % from their equilibrium composition. The mixing coefficient is defined as the ratio of the mixing length to the main channel’s height. As the inlet Kn increases, while ...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:
  • Micromachines

دوره 6  شماره 

صفحات  -

تاریخ انتشار 2015