Passive material properties of intact ventricular myocardium determined from a cylindrical model.
نویسنده
چکیده
The equatorial region of the canine left ventricle was modeled as a thick-walled cylinder consisting of an incompressible hyperelastic material with homogeneous exponential properties. The anisotropic properties of the passive myocardium were assumed to be locally transversely isotropic with respect to a fiber axis whose orientation varied linearly across the wall. Simultaneous inflation, extension, and torsion were applied to the cylinder to produce epicardial strains that were measured previously in the potassium-arrested dog heart. Residual stress in the unloaded state was included by considering the stress-free configuration to be a warped cylindrical arc. In the special case of isotropic material properties, torsion and residual stress both significantly reduced the high circumferential stress peaks predicted at the endocardium by previous models. However, a resultant axial force and moment were necessary to cause the observed epicardial deformations. Therefore, the anisotropic material parameters were found that minimized these resultants and allowed the prescribed displacements to occur subject to the known ventricular pressure loads. The global minimum solution of this parameter optimization problem indicated that the stiffness of passive myocardium (defined for a 20 percent equibiaxial extension) would be 2.4 to 6.6 times greater in the fiber direction than in the transverse plane for a broad range of assumed fiber angle distributions and residual stresses. This agrees with the results of biaxial tissue testing. The predicted transmural distributions of fiber stress were relatively flat with slight peaks in the subepicardium, and the fiber strain profiles agreed closely with experimentally observed sarcomere length distributions. The results indicate that torsion, residual stress and material anisotropy associated with the fiber architecture all can act to reduce endocardial stress gradients in the passive left ventricle.
منابع مشابه
Epicardial suction: a new approach to mechanical testing of the passive ventricular wall.
The lack of an appropriate three-dimensional constitutive relation for stress in passive ventricular myocardium currently limits the utility of existing mathematical models for experimental and clinical applications. Previous experiments used to estimate parameters in three-dimensional constitutive relations, such as biaxial testing of excised myocardial sheets or passive inflation of the isola...
متن کاملShear properties of passive ventricular myocardium.
We examined the shear properties of passive ventricular myocardium in six pig hearts. Samples (3 x 3 x 3 mm) were cut from adjacent regions of the lateral left ventricular midwall, with sides aligned with the principal material axes. Four cycles of sinusoidal simple shear (maximum shear displacements of 0.1-0.5) were applied separately to each specimen in two orthogonal directions. Resulting fo...
متن کاملOptimizing cardiac material parameters with a genetic algorithm.
Determining the unknown material parameters of intact ventricular myocardium can be challenging due to highly nonlinear material behavior. Previous studies combining a gradient-search optimization procedure with finite element analysis (FEA) were limited to two-dimensional (2D) models or simplified three-dimensional (3D) geometries. Here we present a novel scheme to estimate unknown material pa...
متن کاملPii: 0021-9290(93)90357-k
We applied the pseudostrain energy function of Humphrey et al. [J. biomech. Engng 112, 333-346 (1990a, b)] to characterize the passive biaxial mechanical properties of the right ventricle free wall myocardium [Sacks and Chuong, J. biomech. Engng 115,202-205 (1993)]. The myocardium was assumed to be incompressible, pseudoelastic, and transversely isotropic, with transmural variations in fiber or...
متن کاملThe nonlinear elastic and viscoelastic passive properties of left ventricular papillary muscle of a guinea pig heart.
The mechanical behavior of the heart muscle tissues is the central problem in finite element simulation of the heart contraction, excitation propagation and development of an artificial heart. Nonlinear elastic and viscoelastic passive material properties of the left ventricular papillary muscle of a guinea pig heart were determined based on in-vitro precise uniaxial and relaxation tests. The n...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
- Journal of biomechanical engineering
دوره 113 1 شماره
صفحات -
تاریخ انتشار 1991