Explicit use of road topography for model predictive cruise control in heavy trucks

New and exciting possibilities in vehicle control are revealed by the consideration of topography through the combination GPS and three dimensional road maps. This thesis explores how information about future road slopes can be utilized in a heavy truck with the aim at reducing the fuel consumption over a route without increasing the total travel time. A model predictive control (MPC) scheme is used to control the longitudinal behavior of the vehicle, which entails determining accelerator and brake levels and also which gear to engage. The optimization is accomplished through discrete dynamic programming. A cost function is used to define the optimization criterion. Through the function parameters the user is enabled to decide how fuel use, negative deviations from the reference velocity, velocity changes, gear shifts and brake use are weighed. Computer simulations with a load of 40 metric tons shows that the fuel consumption can be reduced with 2.5% with a negligible change in travel time, going from Linköping to Jönköping and back. The road slopes are calculated by differentiation of authentic altitude measurements along this route. The complexity of the algorithm when achieving these results allows the simulations to run two to four times faster than real time on a standard PC, depending on the desired update frequency of the control signals.