Digital Multichannel GPS Receiver Baseband Modules using Model Based Design Tools
نویسندگان
چکیده
This paper deals with the hardware implementation of base band (acquisition and tracking) modules of a GPS receiver using system generator 9.2 has been tried out. The implementation will be tested on Lyrtech (small form factor-software defined radio) platform which consists of 3 layers. The upper layer is the radio frequency (1 GHz) layer, middle layer is the ADACMasterIII layer and the last is digital processing (DSP) layer. The data transfer between the FPGA Virtex-4SX35 and DSP module is done using a TMS320DM6446 Davinci processor. Generation of 17MHz Intermediate frequency has been done. The acquisition module based on parallel code phase search acquisition algorithm has been tried out. The results are being tested for correctness and accuracy. After this the tracking module will be implemented. The results will lead to the development of indigenous GPS receivers with single and multiple channels within the same hardware with reconfiguration.
منابع مشابه
FPGA based GPS receiver design considerations
A project to build a GPS receiver using an FPGA for base-band processing began in 2004. The new receiver platform uses a commonly available RF front end ASIC to convert the GPS signals to a suitable IF. The digital design for baseband processing is normally a reasonably straight forward task. However, because the received GPS signals are at such low levels this presents some challenges. One of ...
متن کاملThe Namuru Open GNSS Research Receiver
Namuru is the name given to the open GNSS receiver research platform developed at the University of New South Wales, Australia. This paper presents the latest design details, results and achievements from the Namuru project team. The platform includes three aspects; 1) a custom circuit board, 2) baseband processor (correlator block) logic design and 3) application firmware. Both the circuit boa...
متن کاملDesign and Implementation of Global Positioning System receiver in field Programmable gate array with Short Message Service
In recent years, survival rate from myocardial infarction and bundle branch block has been increased due to the advancements in medical field. Continuous monitoring and location management of these patients becomes an essential task. Hence this study aims in design and development of GPS in a Field Programmable Gate Array (FPGA) and interfaced with a GSM modem to transmit the location of a civi...
متن کاملSoftware Rake Receiver Enhanced Gps System
Acceleration of semiconductor technologies has enabled incorporation of GPS receivers in small inexpensive hand held battery operated devices. As the size of chipsets for different communication protocols diminishes in size, building multi-protocol communication systems including GPS receivers has become not only attractive but also possible. A limitation of current approaches requires the Base...
متن کاملDesign and Implementation of Field Programmable Gate Array Based Baseband Processor for Passive Radio Frequency Identification Tag (TECHNICAL NOTE)
In this paper, an Ultra High Frequency (UHF) base band processor for a passive tag is presented. It proposes a Radio Frequency Identification (RFID) tag digital base band architecture which is compatible with the EPC C C2/ISO18000-6B protocol. Several design approaches such as clock gating technique, clock strobe design and clock management are used. In order to reduce the area Decimal Matrix C...
متن کامل