Surface Integrated Printed Interdigital Structure for Process Monitoring the Curing of an Adhesive Joint
نویسنده
چکیده
We present a printable interdigital structure, integrated into the surface of a component, to monitor the curing of two adhesively joint components during the fabrication process. In the factory of the future there is a need of new sensor concepts beside the information technological infrastructure. Monitoring of the fabrication enables automated control of the process which improves the quality of adhesive joints. In addition, the cost can be reduced by individually adapted curing times. We demonstrate that cure monitoring with the printed interdigital structure is possible. Two adhesives, a fast and a slow curing one, are analyzed to show the high potential of this process monitoring method.
منابع مشابه
An Interdigital Electrode Probe for Detection, Localization and Evaluation of Surface Notch-Type Damage in Metals
Available microwave notch-type damage detection sensors are typically based on monitoring frequency shift or magnitude changes. However, frequency shift testing needs sweep-frequency data that make scanning detection becomes difficult and time-consuming. This work presents a microwave near-field nondestructive testing sensor for detecting sub-millimeter notch-type damage detection in metallic s...
متن کاملCarbon Nanotube Coated Piezoelectric Ceramic for Self- Health-Monitoring
The sensor signal of Lead Zirconate Titanate (PZT) piezoelectric sensors/actuator surface mounted to a structure with a thin adhesive layer is known to be influenced by the bondline quality and integrity. Monitoring the bondline health of sensor/actuators integrated into structures is becoming a major concern to guarantee the success and reliability of Structural Health Management systems. The ...
متن کاملCharacterisation of Chip-On-Board (COB) Encapsulate Epoxies Used in the Printed Circuit Board Assembly (PCBA) Industry Using Variable Frequency Microwave (VFM) Facilities
In the printed circuit board assembly (PCBA) industry, integrated circuit (IC) dies are attached onto the printed circuit board (PCB) with epoxy. The die pads are first connected to the PCB tracks with gold or aluminium wires, utilising an ultrasonic wire-bonding machine. The dies are then coated with thermally cured epoxy. The chip-on-board (COB) is finally placed in an electrical oven for bak...
متن کاملAn aptasensor based on electrosynthesized conducting polymers, Cu2O–carbon dots and biosynthesized gold nanoparticles, for monitoring carcinoembryonic antigen
Current work proposes an inimitable composite, with great electrical conductivity and quite enhanced surface area, (including conducting polymers (poly (cathechol)), Cu2O–carbon dots and green synthesized gold nanoparticles) for detecting acute carcinoembryonic antigen. At current work, the electropolymerization was offered instead of enzyme-catalyzed polymerization of poly (catechol). <b...
متن کاملEffect of Saliva Contamination and sequencing time of curing the Transbond™ Plus Self Etching Primer on the Shear Bond Strength of Orthodontic Brackets
Abstract Background and aim: Over the years, improvments have been done to simplify clinical bonding procedure. One of these material is Transbond™ Plus Self Etching. The aim of this study was to evaluate the effect of saliva contamination and reusing Transbond™ Plus Self Etching Primer (SEP) on shear bond strength of orthodontic brackets. Materials and Methods: Fifty premolars divided into fiv...
متن کامل