بررسی عوامل حباب‌زای TiH2و CaCO3 بر ساختار وخواص کامپوزیت فومی Al-7%Si-3%SiC

نویسندگان

چکیده مقاله:

In this paper, the effect of TiH2 and CaCO3 blowing agents was investigated on the structure and energy absorption of Al-7%Si-3%SiC composite metal foam by powder compact route. Composition of the foam was prepared from a mixture of Al, SiC and Si powders. Then, precursors were consolidated in H13 die mould by cold and uni-axial pressing at 110 MPa and at room temperature. The pressed precursors were extruded at 500oC, in a 12*24 mm2 cross-section. Then, the precursors were foamed in a 316L-stainless steel tube with diameter and height of 20 mm and 100 mm, respectively, in an electrical resistance furnace. Finally, for micro-structural investigation the samples were cut and polished, and a scanning electron microscope was used to observe the cell wall and surface topology. For calculation and comparison, energy absorption was used in an Instron Hydraulic test machine and the foam samples were compressed at the ramp velocity of 50 mm/minute. Results showed that foams with CaCO3 agent due to having high porosities are more stable than foams with TiH2 agent. Also, the energy absorption for foam with CaCO3 agent is more than foams with TiH2 agents. However, its drainage due to less thickness of wall porosities is better than the foam with CaCO3 agent.

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

بررسی عوامل حباب زای tih۲و caco۳ بر ساختار وخواص کامپوزیت فومی al-۷%si-۳%sic

هدف از مقاله حاضر بررسی ساختار و میزان جذب انرژی فوم پایه فلزی al-7%si-3%sic به روش متالورژی فشردان پودری، توسط دو عامل حباب زای caco3 و tih2 به صورت مستقل است. در تولید فوم فلزی از مخلوط پوردرهای آلومینیم، سیلیسیم و کاربید سیلیسیم به عنوان فاز زمینه استفاده شد. فشرده سازی ترکیبات پودری فوق برای رسیدن به پیش ماده- چگال فوم شونده، به کمک پرس سرد و تک محوره با قالب فولادی h13 در فشار 110 mpa، انج...

متن کامل

بررسی مکانیزم واکنش، ساختار و خواص مکانیکی کامپوزیت درجای تولید شده در سیستم Al-V2O5-NiO

In this study, fabrication of an in-situ composite through aluminothermic combustion synthesis in An Al–V2O5-NiO system was investigated. Therefore, Al, V2O5 and NiO powders with stoichiometric ratio of 11:1:1, respectively, were milled for an  hour and finally the mixtures were compressed. In order to investigate the temperatures of phase transformations, Differential Thermal A...

متن کامل

عنوان پایان نامه: بررسی تاثیر مقادیر مختلف منیزیم بر میکروساختار و خواص مکانیکی کامپوزیت al-7si-10%sic-mg

کامپوزیت های آلومینیم-سیلیسیم با کاربید سیلیسیم به علت داشتن خواصی مانند وزن کم، استحکام مناسب، مقاومت به خوردگی بالا و خواص ماشینکاری خوب بسیار مورد توجه هستند. در این تحقیق اثر منیزیم بر میکروساختار و توزیع ذرات sic و استحکام کششی در کامپوزیت al-7si–xmg–10%sic مورد بررسی قرار گرفته است. به این منظور ابتدا آلیاژ al-7si تولید شده و سپس نمونه های استوانه ای از کامپوزیت با درصد های مختلف منیزیم...

15 صفحه اول

تاثیر عملیات حرارتی و مس بر خواص کششی و اندیس کیفیت آلیاژهای Al-7Si-0.35Mg-xFe

در این تحقیق تاثیر افزودن مس (5/0، 1 و 5/1 درصد) و عملیات حرارتی (6T) بر خواص کششی و اندیس کیفیت آلیاژ 356A حاوی آهن (5/0 تا 5/1 درصد وزنی) بررسی شده است. بر اساس نتایج حاصله، در شرایط ریختگی، افزودن مس به آلیاژهای حاوی آهن موجب افزایش نسبی استحکام کششی (تا حدود 25 درصد) و افت قابل توجه درصد ازدیاد طول (تا حدود 80 درصد) می شود اما در صورت انجام عملیات حرارتی، استحکام کششی و اندیس کیفیت آلیاژ حا...

متن کامل

The Behaviour of Bifilm Defects in Cast Al-7Si-Mg Alloy

Double oxide films (bifilms) are significant defects in the casting of light alloys, and have been shown to decrease tensile and fatigue properties, and also to increase their scatter, making casting properties unreproducible and unreliable. A bifilm consists of doubled-over oxide films containing a gas-filled crevice and is formed due to surface turbulence of the liquid metal during handling a...

متن کامل

منابع من

با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ذخیره در منابع من قبلا به منابع من ذحیره شده

{@ msg_add @}


عنوان ژورنال

دوره 30  شماره 1

صفحات  57- 72

تاریخ انتشار 2011-06

با دنبال کردن یک ژورنال هنگامی که شماره جدید این ژورنال منتشر می شود به شما از طریق ایمیل اطلاع داده می شود.

کلمات کلیدی

کلمات کلیدی برای این مقاله ارائه نشده است

میزبانی شده توسط پلتفرم ابری doprax.com

copyright © 2015-2023