A Procedure for Preparation of Semi-activated Carbon Fiber without any Treatment under High Temperature

نویسندگان

  • Navid Saeidi School of Chemical, Gas and Petroleum Engineering, Semnan University
چکیده مقاله:

A procedure for preparation of semi-activated carbon fiber (SACF) without any treatment under high temperature was proposed. The first step of the procedure is coating of an inorganic fiber (E-glass fiber) by an adsorbent mixture including powder activated carbon, methyl cellulose and water. In this work a set of experiments was performed to attain appropriate adsorbent mixture for good quality of coating. The best composition was investigated based on the adsorption property and the mechanical property of the coated fibers. The results showed that an adsorbent mixture containing 3 wt% or 4 wt% of methyl cellulose, and 15-20 wt% of activated carbon represents good quality of coating. The adsorption property of the coated fibers was studied by determination of iodine number for the adsorbent mixture. In this work the weight percent of the coated adsorbent mixture on the fibers were also obtained and reported. The mechanical property was examined by flowing of air through a packing of the coated fibers. BET surface area of the samples also was examined and compared to other reported works. The results showed that the surfaces area of the samples were eighter equal to or higher than other disclosed works. The weight loss of the coated fibers packing was measured after 20, 40 and 60 min flowing of air through a packing of the SACFs. The weight loss in all cases was very low (up to 0.001 gr); thus good quality of coating can be inferred.

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Activated Carbon Fiber - the Hybrid of Carbon Fiber and Activated Carbon

From application perspectives in adsorption, activated carbon fiber (ACF) is by far one of the most important carbon nanoporous materials to be considered. It has great advantages over other commercial porous storage materials. Activated carbon fiber (ACF) is a promising microporous material with a fiber shape and well-defined porous structure. In general, production of ACF can be commercially ...

متن کامل

Application of a New Self-Cleaning Filter for Colored Wastewaters Treatment Using Laccase Enzyme Immobilized on Activated CARBON powder and fiber

The objective of this work is investigation of the adsorption and decomposition of Reactive Blue 19 from industrial wastewaters using laccase enzyme immobilized on activated carbon powder and fiber as adsorbent. Time, pH, temperature, stirring rate, the amount of the adsorbent, dye initial concentration, solution flow rate in the column and column height were studied as key operating parame...

متن کامل

Preparation and Characterization of Activated Carbon derived from olive stone as adsorbent for Congo Red

Carbon activated powdered was prepared from activated carbon derived from olive stone. Then byusing the surface methodology, many parameters such as pH, furnace temperature (T), acid ratio,time of activation that affect on the qualities prepared activated carbon produced and its efficiencywere investigated. In addition, the adsorption of Congo Red onto the activated olive stone carbonactive was...

متن کامل

Effect of Fiber Surface Treatment on Wear Characteristics of Carbon Fiber Reinforced Polyamide 6 Composites

Ozone modification method and air-oxidation were used for the surface treatment of polyacrylonitrile(PAN)-based carbon fiber. The surface characteristics of carbon fibers were characterized by X-ray photoelectron spectroscopy (XPS). The interfacial properties of carbon fiber reinforced polyamide 6 (CF/PA6) composites were investigated by means of the single fiber pull-out tests. As a result...

متن کامل

degradation of oil impregnated paper insulation under influence of repetitive fast high voltage impulses

در طی سالهای اخیراستفاده ازمنابع انرژی تجدید پذیر در شبکه های مدرن بنا به دلایل زیست محیطی و اقتصادی به طور گسترده استفاده شده است همچون نیروگاههای بادی و خورشیدی .ولتاژتولیدی این نیروگاهها اغلب به فرم dc می باشد وادوات الکترونیک قدرت به عنوان مبدل و پل بین شکل موج dc وac استفاده می شوند.این پروسه باعث ایجاد پالسهایی برروی شکل موج خروجی می شود که می تواند وارد تجهیزات قدرت همچون ترانسفورماتور ی...

15 صفحه اول

منابع من

با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ذخیره در منابع من قبلا به منابع من ذحیره شده

{@ msg_add @}


عنوان ژورنال

دوره 27  شماره 10

صفحات  1519- 1526

تاریخ انتشار 2014-10-01

با دنبال کردن یک ژورنال هنگامی که شماره جدید این ژورنال منتشر می شود به شما از طریق ایمیل اطلاع داده می شود.

میزبانی شده توسط پلتفرم ابری doprax.com

copyright © 2015-2023