Experimental study of impact strength and modulus of elasticity of reinforced concrete under ambient temperature, used in concrete dams

نویسندگان

  • biklaryan, morteza Department of Civil Engineering, Chalous Branch, Islamic Azad University, Chalous, Iran
چکیده مقاله:

The choice of concrete consumption and high strength in the structure of concrete dams is of particular importance. In this laboratory research, slag alkaline concrete containing 0, 4 and 8% nanosilica and 1 and 2% polyolefin fibers has been produced in 5 mixing designs. A design of control concrete containing Portland cement was prepared to compare with the test results of reinforced concrete. Modulus of elasticity, impact resistance of falling hammer and scanning electron microscope images were performed on concrete samples at 90 days of processing age. Addition of nanosilica to reinforced concrete improved (Module 4 compared to Scheme 2) in the modulus of elasticity test and the energy absorbed in the impact test by 13.42% and 36.36%, respectively. This superiority was increased by 7.5% and 8.26 times by adding fibers to concrete, respectively. The results of the SEM test overlap with other results.

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

the effect of taftan pozzolan on the compressive strength of concrete in the environmental conditions of oman sea (chabahar port)

cement is an essential ingredient in the concrete buildings. for production of cement considerable amount of fossil fuel and electrical energy is consumed. on the other hand for generating one tone of portland cement, nearly one ton of carbon dioxide is released. it shows that 7 percent of the total released carbon dioxide in the world relates to the cement industry. considering ecological issu...

Experimental investigation of the strength of glass fiber-reinforced concrete exposed to high temperature

This study investigated the effects of high temperature exposure on the compressive, tensile, and flexural strengths of concrete containing glass fiber. A total of 108 cubic specimens (150 mm × 150 mm × 150 mm), cylindrical specimens (300 mm × 150 mm), and prismatic specimens (500 mm × 150 mm × 150 mm) were prepared for compressive, tensile, and flexural strength testing, respectively. The spec...

متن کامل

Strength of Fine Concrete Used in Textile Reinforced Concrete by Changing Water-Binder Ratio

Recently, the abnormal climate phenomenon has enlarged due to the global warming. As a result, temperature variation is increasing and the term is being prolonged, frequency of high and low temperature is increasing by heat wave and severe cold. Especially for reinforced concrete structure, the corrosion of reinforcement has occurred by concrete crack due to temperature change and the durabilit...

متن کامل

Relationship between compressive strength and modulus of elasticity of High-Strength Concrete

Modulus of elasticity of concrete is frequently expressed in terms of compressive strength. While many empirical equations for predicting modulus of elasticity have been proposed by many investigators, few equations are considered to cover the entire data. The reason is considered to be that the mechanical properties of concrete are highly dependent on the properties and proportions of binders ...

متن کامل

A mathematical model for optimization of strength of concrete: A case study for shear modulus of Rice Husk Ash Concrete

Rice Husk Ash (RHA) is natural Pozzolan containing reactive silica and/or aluminum. When the material is mixed with lime in powdered form and in the presence of water, it will set and harden like cement. This work uses Osadebe’s optimization model to optimize the shear modulus of concrete made from RHA. The strengths predicted by the model are in good agreement with their corresponding experime...

متن کامل

Experimental Investigations on The Flexural Strength of PET Reinforced Concrete

Due to the rapid industrialization taking place globally, the problems generated are acute shortage of construction material and increasing in productivity of wastes. The production and consumption of plastic and the rate at which solid plastic waste (SPW) are created have increased considerably. Plastics constitute 12.3% of total waste produced most of which is from discarded water bottles. Th...

متن کامل

منابع من

با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ذخیره در منابع من قبلا به منابع من ذحیره شده

{@ msg_add @}


عنوان ژورنال

دوره 8  شماره None

صفحات  54- 61

تاریخ انتشار 2022-03

با دنبال کردن یک ژورنال هنگامی که شماره جدید این ژورنال منتشر می شود به شما از طریق ایمیل اطلاع داده می شود.

کلمات کلیدی

کلمات کلیدی برای این مقاله ارائه نشده است

میزبانی شده توسط پلتفرم ابری doprax.com

copyright © 2015-2023