Kinetic Study and Modelling of n-Heptane Reforming Process over Pt/Zr-HMS/HZSM-5 Composite Catalysts

نویسندگان

  • Amir Sajedi Faculty of Chemistry Science and Petroleum, Department of Physical Chemistry, University of Shahid Beheshti, Tehran, 1983963113, Iran
چکیده مقاله:

Pt/Zr(x)-HMS/HZSM-5 catalysts with various Si/Zr ratios (as x) were used for investigation of the kinetics of n-heptane reforming process under 350 - 450 oC reaction temperature, 35 to 80 ml min-1 flowing rate of hydrogen and 2 to 5 ml h-1 flowing rate of n-heptane. In the present work, two kinetics (power law and Langmuir - Hinshelwood) models were selected and examined to describe the kinetics of the n-heptane reforming process over the used catalysts. The results show that the Langmuir - Hinshelwood model provides a better fit with the experimental data and allows to determine the kinetics parameters. Among the synthesized catalysts, Pt/Zr(35)-HMS/HZSM-5 (with Si/Zr = 35) has the best performance for this process. Because this catalyst in contrast to others, based on the apparent activation energies, has a fast formation of aromatic and isomeric products, and low rate on the production of by-products, such as cracking and hydrogenolysis products.

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Normal Heptane Reforming of Promoted Platinum Composite Catalysts: Preparation, Characterization and Catalytic Performance

Pt/Zr(x)-HMS/HZSM-5 catalysts with different ratios of Silicium/Zirconium (denoted as x) were studied for normal heptane reforming at 350-450 °C temperature range. For this purpose, the properties of the catalysts such as X-ray diffraction, X-ray fluorescence, Fourier-transform infrared spectroscopy, Ultraviolet–visible diffuse reflectance spectroscopy, NH3-temperature pro...

متن کامل

Steam reforming of methanol over Cu/ZrO2/CeO2 catalysts: a kinetic study

Steam reforming of methanol (SRM) was investigated over Cu/ZrO2/CeO2 (CZC) catalysts prepared via a novel synthetic method based on coprecipitation and polymer templating. Structural characterization of the samples was performed by N2 adsorption-desorption, N2O decomposition, and X-ray diffraction. The variation of the Cu loading resulted in an increased Cu crystallite size and a decreased spec...

متن کامل

Catalytic Performance and Kinetic Study in the Total Oxidation of VOC over Micro/Meso Porous Catalysts

The total oxidation of toluene at a wide temperature range (200–500 oC) over micro/mesoporous platinated catalysts has been investigated about activity, selectivity to CO2 and CO, catalyst's stability versus coke deposition and reaction kinetics. Kinetic of toluene oxidation was measured under various oxygen and toluene pressures and als...

متن کامل

Hydrogen production by steam reforming of dimethyle ether over Cu/ZnO/Al2O3 and H-ZSM-5 catalysts: An experimental and modeling study

Hydrogen was produced by steam reforming of dimethyl ether (DME) using a physical mixture of commercial HZSM-5 zeolite (for DME hydrolyzing) and Cu/ZnO/Al2O3 (for methanol steam reforming) as a catalyst in a fixed bed reactor. The experiments were performed at atmospheric pressure and in a temperature range from 270 to 310 °C. The effects of feed temperature and gas hourly space velocity (GHSV)...

متن کامل

Low-Temperature Chemical Kinetic and Speciation Studies of n-Heptane

Although there have been many studies of n-heptane ignition, few studies have provided detailed insights into the low-temperature chemistry of n-heptane—a primary reference fuel— through direct measurements of intermediate species formed during ignition. Such measurements provide understanding of reaction pathways that form toxic air pollutants, greenhouse gas emissions, and particulates such a...

متن کامل

CATALYTIC REFORMING OF n-HEPTANE ON PLATINUM-TUNGSTEN SUPPORTED ON GAMMA-ALUMINA

The mono-metallic and bi-metallic catalysts have been prepared by impregnating with solutions containing a compound of H2PtCl6,WO3 and 1ml HCl (0.1 mol). It should be noted that the catalysts’ activity and selectivity have been determined under these conditions : 450-5000C ,and 15-25atm by H2. For converting n-heptane , the molar ratio H2/C7H16 is 5 , and LHSV is 1.5ml/h. It has been proved tha...

متن کامل

منابع من

با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ذخیره در منابع من قبلا به منابع من ذحیره شده

{@ msg_add @}


عنوان ژورنال

دوره 7  شماره 1

صفحات  1- 9

تاریخ انتشار 2019-03-01

با دنبال کردن یک ژورنال هنگامی که شماره جدید این ژورنال منتشر می شود به شما از طریق ایمیل اطلاع داده می شود.

میزبانی شده توسط پلتفرم ابری doprax.com

copyright © 2015-2023