Non-Linear Behavior of New (FSFN) Moment Resisting Connections in Comparison to the Existing KBB Connections in Steel Frames

نویسندگان

  • Farhood Shahidi Civil Engineering, Islamic Azad University of Takestan
چکیده مقاله:

After Northridge (1994) and Kobe (1995) earthquakes, several studies have been conducted to improve the seismic performance of steel structures. In this investigation, new steel moment-resisting connections (FSFN) developed by the authors, were studied by the non-linear numerical analysis. These connections were single-sided beam-to-column assemblies that are representative of exterior beam-to-column connections. Seismic performance of FSFN connections in comparison to the W-series of existing KBB connections under standard and near fault load history based on AISC 341 and FEMA 355D were also studied. For this purpose, 32 analytical modeled specimens were evaluated and the results were compared. Results showed that FSFN bracket connection has a seismic performance similar to KBB connection and it is an appropriate connection for the special moment resisting frames both in far and near fault zones.  More so, these connections do not have patent and due to their dimensions which are smaller than the Kaiser brackets, they can supported deeper beams up to 100 cm.  Therefore, it can be considered as an appropriate alternative for the Kaiser patented connections. This paper is to present the analytical modeling, non-linear behavior and the results of the comparison studies in detail including obtained conclusions.

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Numerical Analysis of Cyclic Behavior of Beam-To-Column Bolted Connections in Steel Frames

This article considers the seismic behavior of beam-to-column joints in steel frames for different bolt arrangements by using of finite element modeling. As the most important beam-to-column joint type, the beam-to-column joints with end-plate is chosen for the analysis. Four different specimens have been analyzed. These models had some differences such as bolt arrangement and the presence or a...

متن کامل

Influential Factor in Improving the Seismic Performance of the Kaiser Bolted Bracket Moment Connection

Following the Northridge earthquake of 1994, a significant number of steel moment resisting structural systems were damaged. Several studies have been conducted to improve the seismic performance of steel structures and specially their beam-to-column connections. One of the proposed connections for special moment-resisting frames included AISC-358 is Kaiser bolted bracket moment connection, bri...

متن کامل

Seismic behavior of drilled beam section in moment connections

Abstract: Reduced Beam Section (RBS) and Drilled Beam Section (DBS) are seismic moment resistant frame connections, introduced after 1994 Northridge earthquake. RBS connection has been tested under cyclic loading and showed acceptable performance. In this paper, seismic behavior of Drilled Beam Section (DBS) connection is studied numerically using finite element method. A drilled beam section ...

متن کامل

Moment-resisting connections in glulam beams

This paper describes an experimental investigation into the use of steel bars bonded into glulam timber beams with epoxy resins in order to provide moment-resisting joints between glulam beams and steel supports. The objective of this research was to provide information about the bending and shear strength of such connections. Past research has investigated the use of steel rods epoxy bonded in...

متن کامل

Robustness Assessment of Steel Moment Resisting Frames

Nowadays, many buildings with steel Moment Resisting Frames (MRF) are built in seismic zones when seismic codes are at its early stages of development, and as such, these structures are often designed solely to resist lateral wind loads without providing an overall ductile mechanism. On the other hand, current seismic design criteria based on hierarchy of resistance allow enhancing the structur...

متن کامل

Numerical study on the behavior of link-to-column connections in eccentrically braced frames

Geometry of eccentrically braced frames (EBFs) in some cases causes the connection of link beam to the column. The details of such conditions should be studied carefully due to the full plastic rotation in the link beam. In this research, the behavior of link-to-column connection is modeled and the failure modes are considered. Based on the previous researches shear link can exhibit better beha...

متن کامل

منابع من

با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ذخیره در منابع من قبلا به منابع من ذحیره شده

{@ msg_add @}


عنوان ژورنال

دوره 26  شماره 10

صفحات  1119- 1134

تاریخ انتشار 2013-10-01

با دنبال کردن یک ژورنال هنگامی که شماره جدید این ژورنال منتشر می شود به شما از طریق ایمیل اطلاع داده می شود.

میزبانی شده توسط پلتفرم ابری doprax.com

copyright © 2015-2023