نتایج جستجو برای: outer tube flow

تعداد نتایج: 628881  

2015
G. A. Yahya A. M. Abd-Alla

The objective of this project is to study examines the problem of peristaltic flow in a tube with an endoscope subjected to rotation. The effect of an endoscope and rotation of the peristaltic flow of a Jeffrey fluid through the cylindrical cavity between concentric tubes is investigated. The analytical expressions for the pressure gradient, velocity, pressure rise, friction force on the inner ...

Journal: :Chemical Engineering and Processing 2022

• Dynamics of driven ATR characterised experimentally and numerically. Optical acoustic methods agree well with LBM numerical model. Mixing regime depends strongly on applied amplitude, a , agitation frequency, f . power number increases re as 2 3 above critical value. Agitator tube induces fluid wakes, motion closely coupled to velocity field. This study investigates the dynamics novel, oscill...

Journal: :Energies 2023

One of the effective methods for energy conservation and emission reduction in coal mines is to utilize waste heat recovery technology recover mine return air heat. The gravity pipe widely used due its sustainable economic advantages, but transfer a complex process influenced by multiple parameters. A single-tube resistance model calculation based on enthalpy difference were established exchang...

Journal: :Iraqi journal of science 2023

In this work, the mathematical modelling of peristaltic transport for incompressible Sutterby fluid through cavity between coaxial tubes where inner tube is fixed and outer has sinusoidal rhythmic fluctuations along channel’s walls presented. Under assumption long wavelength low Reynolds number, governing equations (motion, temperature, concentration) are illustrated in cylindrical coordinates....

In the present study, the effective parameters of water-Al2O3 nanofluid flowing in flat tubes are investigated using the EFAST Sensitivity Analysis (SA) method. The SA is performed using GMDH type artificial neural networks (ANN) which are based on validated numerical data of two phase modeling of nanofluid flow in flat tubes. There are five design variables namely: tube flattening (H), flow ra...

2014
Ami Nomura Ken Imanishi Yukinori Taniguchi Etsuko Ueda Tadahiro Wada Shinichi Enoki

Recently, there have been a lot of earthquakes in Japan. It is necessary to promote seismic isolation devices for buildings. The devices have been hardly diffused in attached houses, because the devices are very expensive. We should develop a low-cost seismic isolation device for detached houses. We suggested a new seismic isolation device which uses a two-layer circular tube as a unit. If hyst...

ژورنال: دریا فنون 2019

This paper examines the total annual cost from economic view heat exchangers based on ant colony optimization algorithm and compared the using optimization algorithm in the design of economic optimization of shell and tube heat exchangers. A shell and tube heat exchanger optimization design approach is expanded based on the total annual cost measured that divided to area of surface and power co...

Journal: :Shock Waves 2023

Abstract In the present work, operation characteristics of a disk-type rotating detonation engine (DRDE) with constant chamber area were experimentally studied for various total mass flow rates and wide variety equivalence ratios hydrogen–air mixtures. From direct visualizations, wave was found to propagate near outer wall combustion chamber, regardless mode. For test conditions, single- double...

Introduction: In the present experimental investigation, the thermal and electrical performances of a photovoltaic/thermal system equipped with a sheet-and-grooved serpentine tube collector are investigated. The water-magnetite nanofluid is used as the heat transfer fluid. The effect of nanoparticle volume concentration (0-1%), nanofluid mass flow rate (10-40 kg/h) and groove pitch (0, 0.54 an...

Abstract   An empirical investigation was carried out to study convective heat transfer of nanofluid flow inside an inclined copper tube under uniform heat flux condition. Required data are acquired for laminar and hydrodynamically fully developed flow inside round tube. The stable CuO-base oil nanofluid with different nanoparticle weight fractions of 0.5%, 1% and 2% was produced by means of ul...

نمودار تعداد نتایج جستجو در هر سال

با کلیک روی نمودار نتایج را به سال انتشار فیلتر کنید