Pull-out experiments were performed on four carbon fiber-reinforced polymer (CFRP) ground anchors simulating their applications in rock and soil. The CFRP tendons used in these anchors comprise a single-strap end on both the ground and air sides. On the ground side, the single-strap end is embedded in a cylinder of high-strength grout which fits into the borehole. In rock applications, the grou...

This paper describes new concepts the author has proposed and demonstrated to realize metal and polymer based sensitive and/or active structural material systems suitable for smart structures. Most of the developments have been done by simple and innovative methods without using sophisticated and expensive sensors and actuators. The following topics are mainly examined: (1) forming optical inte...

An investigation has been made of the potential of pulsed transient thermography for identifying the location of fixtures beneath aircraft skins to facilitate accurate automated assembly operations. Experimental studies have been made of 1.6mm thick aluminium skins and both 2mm and 4mm thick carbon fibre reinforced plastic (CFRP) composite skins over both aluminium and composite struts, represe...

This study presents a design criterion developed for fatigue strengthening of a 120-year-old metallic railway bridge in Switzerland and presents a pre-stressed un-bonded reinforcement (PUR) system developed to apply the strengthening. The PUR system uses carbon fiber reinforced polymer (CFRP) plates; however, unlike conventional pre-stressed CFRP reinforcement methods, preparation of the existi...

the aim of this research is to investigate the effect of carbon fiber reinforced polymer (cfrp) composite fabric on monotonic and fatigue behaviors of reinforced concrete beams. to control the failure occurrence, a small notch was induced at the middle span in bottom surface for all of the studied rc specimens. totally 12 beams were tested from which 6 beams tested under monotonic and 6 other t...

A quick method involving the control of heat and water vapor pressure for preparing moisture-saturated carbon fiber-reinforced plastics (CFRP, 8 unidirectional prepreg layers, 1.5 mm thickness, epoxy resin) has been developed. The moisture-saturated CFRP sample was obtained at 120 ̋C and 0.2 MPa water vapor in 72 h by this method using a sterilizer (autoclave). The bending strength and viscoela...

We implanted titanium and carbon fibre-reinforced plastic (CFRP) femoral prostheses of the same dimensions into five prosthetic femora. An abductor jig was attached and a 1 kN load applied. This was repeated with five control femora. Digital image correlation was used to give a detailed two-dimensional strain map of the medial cortex of the proximal femur. Both implants caused stress shielding ...

This paper presents results of testing twelve hollow square reinforced concrete specimens wrapped with Carbon fibre reinforced polymer CFRP. The effect of ply configuration on the behaviour of the specimens is investigated. All specimens were 800mm high and had the dimensions of 200mm× 200mm in cross-section and a hollow core of 80mm× 80mm. The specimens were divided into four groups with three...

Delamination monitoring in carbon fiber reinforced polymer (CFRP) laminated plates is crucial to ensure the integrity and safety of the structures that accommodate the plates. To identify delaminations in CFRP laminated plates, the two-dimensional (2D) curvature mode shape method is a prevailing method that features instant and simultaneous determination of the presence and location of the dela...