As the analysis tool the well-known commercial software package (FINE/Design3D) is used. As the optimization software IOSO PM (parallel algorithm of IOSO) is used. The prospect presents the results of optimizing a three-stage axial compressor. The optimization goal was to improve the compressor efficiency at two flight conditions by optimizing geometry of the 5 compressor rows (62 design parame...

This paper presents a new (5:2) compressor circuit capable of operating at ultra-low voltages. I t s power efficacy is derived from the novel design of composite XOR-XNOR gate at transistor level. The new circuit eliminates the weak logic and threshold voltage drop problems, which are the main factors limiting the performance of pass transistor based circuits at low supply voltages. The propose...

surge is one of the two destructive factors in compressors. surge is the stream instability phenomenon in compressor that imposes severe damages to the compressors. nowadays, suppressingsurge phenomenon is one of the most important issues in oil and gas industries, especially when flow reduction or gas reflux is considered. according to moore-greitzer compressor model, this paper designs an act...

A new 1-bit full adder (FA) cell illustrating low-power, high-speed, and a small area is presented by combination of transmission gate (TG), pass transistor logic (PTL), float techniques. Using the proposed cell, 4:2 compressor implemented its performance investigated under diverse circumstances voltage, temperature, driving. The process corners are evaluated through process-voltage-temperature...

The performance prediction of axial flow compressors at different speeds and under various pressure ratio conditions are still being developed because of costly empirical experiments. One-dimensional modeling is a simple, fast and accurate method for performance prediction in any type of compressor with different geometries. In this approach, inlet flow conditions and compressor geometry are kn...

A novel CMOS 4-2 compressor using pass logic is presented in this paper. An XOR-XNOR combination gate is used to build the circuit while totally eliminating the use of inverters. The total power dissipation has been cut down to a minimum while providing the full output voltage swing at all nodes in the circuit. Furthermore, the complete circuit is implemented with a bare minimum of 28 transistors.

Jay Kim Structural Dynamics Research Laboratory University of Cincinnati Cincinnati, OH 45221-0072 Since the suction accumulator is one of components with large surface area in rolling piston type rotary compressors, its contribution to the total radiated noise may be substantial. In this study, possible noise sources of the accumulator are discussed. The noise radiated from accumulators are pr...

The design and dynamic characterization of a free piston compressor is presented in this paper. The free piston compressor is a proposed device that utilizes combustion to compress air into a high-pressure supply tank. The device is configured such that the transduction from thermal energy to stored energy, in the form of compressed gas, is efficient relative to other small-scale portable power...