the aim of the present study was to investigate the effect of quenching and tempering temperatures on themicrostructure, mechanical properties and the wear characteristics of medium carbon-high chromium wear resistantsteel. in addition, the dominant wear mechanisms were studied. for this purpose, austenitizing and temperingtemperatures were selected in the ranges of 900- 1000 °c and 300- 500 °c...

The current paper aims to review tooling life span, failure modes and models in cold microforming processes. As there is nearly no information available on tool-life for microforming the starting point was conventional cold forming. In cold forming common failures are (1) over stressing of the tool; (2) abrasive wear; (3) galling or adhesive wear, and (4) fatigue failure. The large variation in...

A series of experiments on friction and wear properties of carbon strip rubbing against copper contact wire is performed on high-speed friction and wear tester with electric current. The results show that the friction coefficient is generally maintained between 0.24 and 0.37. In the absence of electric current, the coefficient of friction is higher than that in the presence of electric current....

The effect of cutting parameters and tool parameters on cutting forces and tool wear were investigated in high density fiberboard (HDF) peripheral up-milling using toughened ceramic cutting tools. The results showed that whether at low speed cutting or high speed cutting, the tangential forces Ft and normal forces Fr increased slowly with the increase of cutting length. The tangential forces Ft...

The wear behaviour of total knee arthroplasty (TKA) is dominated by two wear mechanisms: the abrasive wear and the delamination of the gliding components, where the second is strongly linked to aging processes and stress concentration in the material. The addition of vitamin E to the bulk material is a potential way to reduce the aging processes. This study evaluates the wear behaviour and dela...

Wear of polyethylene is associated with aseptic loosening of orthopaedic implants and has been observed in hip and knee prostheses and anatomical implants for the shoulder. The reversed shoulder prostheses have not been assessed as yet. We investigated the volumetric polyethylene wear of the reversed and anatomical Aequalis shoulder prostheses using a mathematical musculoskeletal model. Movemen...

In the present research work, effect of several process parameters on the machining characteristics of borosilicate glass has been reported. The machining characteristics that are being investigated are material removal rate (MRR) and tool wear rate (TWR). Four different process parameters were considered for this study power rating of the machine, static load, slurry concentration and abrasive...

Oxidative degradation of ultra-high molecular weight polyethylene (UHMWPE; PE), due to gamma irradiation sterilization in air, increases wear rate in artificial joint. Not only adhesive and abrasive wear but also delamination (flaking), a typical wear of the PE component in artificial knee joint, and fracture could be observed. This paper deals with gamma-irradiation effects on severe wear mech...

Carbon-fiber-reinforced silicon carbide (C/C-SiC) composite is widely used as a friction material owing to its good performance, even though it is more expensive than metallic materials. The light C/C-SiC composite is an ideal candidate for weight reduction of frictional parts. In this study, the friction and wear behavior of C/C-SiC composite was assessed using a ball-on-disk friction tester u...

A cold sprayed Al coating on S355 structural steel was processed using a laser remelting (LR). The surface and cross-section morphologies, chemical compositions, and phases of as-obtained Al coating before and after LR were analyzed using a scanning electronic microscope (SEM), energy dispersive spectrometer (EDS), and X-ray diffractometer (XRD), respectively, and their hardness was measured us...