during the past two decades, the use of bioplastics as an alternative to regular plastics has received much attention in many different industries. the mechanical and degradable properties of bioplastic are important for their utilization. in this research cellulose of wheat straw and glycerol were mixed by different weight ratios and then reinforced by using date palm fibers. to prepare the bi...

The increase of patients with osteoporosis is a social problem. Osteoporosis decreases bone strength and increases the risk of fracture. The finding of prevention and treatment methods is an urgent issue. Since cancellous bone is metabolically more active than cortical bone, cancellous bone is used for diagnosis of osteoporosis. There are a lot of studies about stress analysis of cancellous bon...

Gears are an integral and necessary component in our everyday lives. Most of the work performed in plastic and metal but very few works available in combine effect of plastic and metal gears. The main problem while referring plastic gear is the bending strength and in case of metal gear is cost. Hence, the work is performed on metal plastic composite gear to get benefit of both. Here use the co...

tobacco is planted extensively in golestan province and high volume of its stem wastes remained without using and it is burned. as a useful purpose of these wastes and to reduce the environmental problems, in this the mechanical properties of polypropylene composites reinforced with tobacco stalk flour were studied. for this purpose, the tobacco stalk flour as the reinforcement, in three levels...

C-SiC composites with carbon-based mesocarbon microbeads (MCMB) preforms are new type of highpreformance and high-temperature structural materials for aerospace applications. In this study MCMB-SiC composites with high density (2.41 g.cm-3) and high bending strength (210 MPa,) was prepared by cold isostatic press of mixed mesophase carbon powder derived from mesophase pitch with different amoun...

This paper presents the results of an experiment to investigate the high cycle fatigue properties of the ultra-high strength steel TM210A. A constant amplitude rotating bending fatigue experiment was performed at room temperature at stress ratio R = -1. In order to evaluate the notch effect, the fatigue experiment was carried out upon two sets of specimens, smooth and notched, respectively. In ...

This study investigated the influence of porosity on the flexural property of a nanoporous alumina film. When the porosity of the alumina film increased, both bending strength and modulus declined. The results from the bending test revealed that the setting of the film during the bending test had significant influence on the flexural property. Fracture only occurred when the porous side of the ...

Structures and testing methods for measuring the adhesion strength, minimum bending diameter, and bending fatigue performance of thin-film polymer electronic architectures were developed and applied to Parylene–metal–Parylene systems with and without the moisture barrier Al2O3 [deposited using atomic layer deposition (ALD)]. Parylene–metal– Parylene interfaces had the strongest average peel tes...