Cable interference in cable-driven mechanisms (CDM) is a major challenge in their applications. The wrench closure workspace (WCW) in a fully constrained mechanism may not be realized unless cable interference is considered. This paper classifies all possible types of cable interferences for planar cable-driven mechanisms and presents an analytical solution to find the boundaries of the constan...

This article presents a new planar translational cable-direct-driven robot 1 (CDDR) with actuation redundancy and supported against loading normal to the 2 motion plane with a passive planar two-degree-of-freedom SCARA-type (Selective 3 Compliance Assembly Robot Arm) serial manipulator. This allows the robot to 4 resist cable sag without being supported on the motion plane. The proposed robot 5...

This paper presents design and kinematic analysis for a cable-driven parallel robotic (CDPR) manipulator with four cables, The CDPR manipulator produces a planar motion including two translational and one rotational degrees of freedom. To move the end-effector of CDPR, its kinematic structure is analyzed and the inverse kinematics is formulated in the closed-form solution. The experimental test...

We show the design and implementation of a robot controller with a unique locomotion system. We demonstrate that a discrete-event simulation based design provides a cost-effective, flexible , open workflow for modular robotic development. The robot is designed to translate against a vertical surface using cables fixed at one end that can wind on motor-controlled spools attached to the robot. Th...

The Dynamic Tensegrity Robotics Lab (DTRL) at the NASA Ames Research center is actively researching the design, control, and locomotion of tensegrity robots for planetary exploration. The advantage of using a tensegrity robot emerges from the fact that it behaves as a structured soft robot. This term, structured soft robotic system, comes from the fact that tensegrity systems are traditionally ...

1 No approval or endorsement of any commercial product by the National Institute of Standards and Technology is intended or implied. Certain commercial equipment, instruments, or materials are identified in this report in order to facilitate understanding. Such identification does not imply recommendation or endorsement by the National Institute of Standards and Technology, nor does it imply th...

This paper presents a new geometry-based method to determine if a cable-driven robot operating in a d-degree-of-freedom workspace (2 ≤ d ≤ 6) with n ≥ d cables can generate a given set of wrenches in a given pose, considering acceptable minimum and maximum tensions in the cables. To this end, the fundamental nature of the Available Wrench Set is studied. The latter concept, defined here, is clo...