An in-situ characterization technique combining mechanical testing inside a scanning electron microscope (SEM) with electron backscatter diffraction (EBSD) analysis was employed to study the tensile deformation behavior of Nd-containing Mg alloys over the temperature range of 50-250°C. EBSD data were collected before and after the experiments. The active slip and twinning systems were identifi ...

A variable stiffness fiber made of silicone and low melting point alloys quickly becomes >700 times softer and >400 times more deformable when heated above 62 °C. It shows remarkable self-healing properties and can be clamped, knitted, and bonded, as shown in a foldable multi-purpose drone, a wearable cast for bone injuries, and a soft multi-directional actuator.

The objective of this study was to investigate the joint properties between cast gold alloys and Co-Cr alloy laser-welded by Nd:YAG laser. Cast plates were fabricated from three types of gold alloys (Type IV, Type II and low-gold) and a Co-Cr alloy. Each gold alloy was laser-welded to Co-Cr using a dental laser-welding machine. Homogeneously-welded and non-welded control specimens were also pre...

We have studied the mechanical properties of monolithic bulk metallic glasses and composite in the La based alloys. La86-yAl14(Cu, Ni)y (y=24 to 32) alloy systems was used to cast the in-situ structure and subsequently tested under compression. We found that the ductility of the monolithic is actually poorer than that of the fully crystalline composite.

Aim: The aim of this study was to compile the usage of Co-Cr alloys in fixed prosthodontics (FP) among dental laboratories in Sweden. Methods: From March to October 2015, questionnaires were sent to 542 registered dental laboratories in Sweden. The questionnaires were divided in two parts, one for fixed dental-supported prosthodontics (FDP) and one for fixed implant-supported prosthodontics (FI...

The aim of this research was to evaluate the effect of individual metallic elements within experimental Au-Pt-based metal-ceramic alloys on in vitro biocompatibility. A binary Au-10 at.% Pt alloy (AP10) was designed as a parent alloy. Six ternary AP10-X (X = In/Fe/Sn/Zn) alloys and four quaternary (AP10-In2)-Y (Y = Fe/Sn/Zn) with different compositions were cast into square plates with size 10X...

Master moulds are used to cast copper anode moulds. These iron moulds are made of grey or nodular cast irons. According to desirable properties of ductile irons, it was expected that ductile cast iron ...

Ferrous metals include cast iron, steel, and the various steel alloys, The only difference between iron and steel is the carbon content. Cast iron contains more than 2-percent carbon, while steel contains less than 2 percent. An alloy is a substance composed of two or more elements. Therefore, all steels are an alloy of iron and carbon, but the term “alloy steel” normally refers to a steel that...

in this research the effect of volume and morphology of eutectic carbides on tribological behaviour of ni-hard 4 cast irons have been investigated. therefore, as a result of the fact that the carbon content effects the carbides morphology of ni-hard cast irons, the chemical compositions of five different specimens were kept constant with the exception of the carbon content, which was varied fro...

Insertion of metal implants is associated with a possible change in the delicate balance between pro- and anti-inflammatory proteins, probably leading to an unfavourable predominantly pro-inflammatory milieu. The most likely cause is an inappropriate activation of macrophages in close relation to the metal implant and wear-products. The aim of the present study was to compare surfaces of as-cas...