Due to the increasing depletion of petroleum resources, production route non-oil-based aviation kerosene has been paid more and attention. In this regard, process preparing from syngas (CO H2) is one most promising industrial alternative fuel routes. The traditional syngas-to-aviation catalyst uses iron-based cobalt-based catalysts, which a complex with high cost. work, hierarchical Co/Beta met...

This paper presents the synthesis and characterization of monometallic and bimetallic cobalt and iron nanoparticles supported on alumina. The catalysts were prepared by a wet impregnation method. Samples were characterized using temperature-programmed reduction (TPR), temperature-programmed oxidation (TPO), CO-chemisorption, transmission electron microscopy (TEM), field emission scanning electr...

The properties of 20 wt % CeO2 and 21 wt % Ce0.5Zr0.5O2 films, deposited onto a γ-Al2O3 by Atomic Layer Deposition (ALD), were compared to bulk Ce0.5Zr0.5O2 and γ-Al2O3-supported samples on which 20 wt % CeO2 or 21 wt % CeO2–ZrO2 were deposited by impregnation. Following calcination to 1073 K, the ALD-prepared catalysts showed much lower XRD peak intensities, implying that these samples existed...

The influence of adding manganese to an Al2O3 support for preparing NiMo catalysts the hydroconversion soybean oil was herein evaluated. Two different Mn contents (1 and 5 mol % Mn) were used while Al2O3-Mnx (x = 1 or obtained by sol-gel method. wetness co-impregnation nickel molybdenum precursors onto as-formed supports considering two pH impregnation (5 9). Solids then characterized at oxide ...

   In this research carbon nanotubes were produced by chemical vapor deposition of acetylene over a mixture of iron and cobalt catalysts supported on nanometric TiO2 and the influences of two synthesis parameters: growth temperature and catalyst composition ratio on properties of end-product carbon nanotubes were investigated. The catalytic basis was prepared by wet impregnation ...

Utilization of active and stable catalyst could have enormous advantages in industrial application of biogas reforming. In order to achieve this goal, the effects of Cu and Co as promoters were investigated over physical-chemical properties of Ni/Al2O3-ZrO2 catalyst in reforming of biogas. The sequential impregnation was used for preparation of catalysts. The catalysts were characterized using ...

In this work, we show that if the mere procedure of impregnation of oxide supports with chloroauric acid, which is well-known to lead to large gold particles, is followed by a step of washing with ammonia, small gold particles (3-4 nm) can be obtained after a treatment of calcination at 300 degrees C on any type of oxide supports (alumina, titania, silica). Moreover, gold leaching is very limit...

Pd-, Cu-, Ni- and NiCu-BaZr₀.₁Ce₀.₇Y₀.₁Yb₀.₁O₃₋δ anodes, designated as M-BZCYYb, were prepared by impregnating M-containing solution into BZCYYb scaffold, and investigated in the aspects of electrocatalytic activity for the reactions of H₂ and CH₄ oxidation and the resistance to carbon deposition. Impregnation of Pd, Ni or NiCu significantly reduced both the ohmic (RΩ) and polarization (RP) los...