The objective of this study was to determine the chemical, radiological and leaching properties of slag and ash produced by a thermoelectric unit of a former factory Adriavinil and deposited in the area of Kasktel Gomilica near Split, Croatia. A total of 33 samples were analysed. The bioavailable fraction of the slag and ash was estimated using different leaching tests. The waste material was c...

Radiation doses from airborne effluents of model coal-fired and nuclear power plants (1000 megawatts electric) are compared. Assuming a 1 percent ash release to the atmosphere (Environmental Protection Agency regulation) and 1 part per million of uranium and 2 parts per million of thorium in the coal (approximately the U.S. average), population doses from the coal plant are typically higher tha...

and ECA coal analysers have been used to control sorting and blending operations at coal mines, power plants and coal terminals. In sorting operations, the analyser results are used to sort coal into piles, bins or silos based on the measured quality. Coals can be sorted by the ash, sulphur, moisture, heating value, or by combinations of these. Sorting can be used to allow low-ash coals to bypa...

Lignite from Mae Moh mine is the largest source of solid fuel for electricity generation in Thailand. It is used in pulverized coal-fired boilers of a 2400 MW thermal power plant. Its high CaO content in ash is a major concern that can affect severe slagging. In this paper, potential of slag occurrence in the power plant was investigated by numerical simulation. The FactSage thermochemical pack...

This study investigates the flotation performance of a representative hard coal slime sample (d80 particle size of minus 0.2 mm) obtained from the Prosper-Haniel coal preparation plant located in Bottrop, Germany. Flotation was carried out with a newly designed flotation cell refurbished from an old ultrasonic cleaning bath (2.5 L volume) equipped with a single frequency (35 kHz) and two differ...

Spherical and hollow fly ash particles having density < 1g/cm are known as cenospheres. Their concentration in coal combustion ash is typically << 1%; as a consequence, their value is relatively high (~$0.70/kg). However, cenospheres are really particles containing gas bubbles independent of their density. Hence, cenosphere densities can vary between 0.6 g/cm to near or greater than 2.0 g/cm. T...

Large reserves of coal in Tabas region of Iran are characterized by low ash and high caking index, suitable for use in metallurgy as coking coal. However, these coals cannot be gainfully utilized because of their high sulfur content. In this work, studies on desulfurization of Tabas coals were carried out in a batch reactor using various reagents. The most effective reagents,<...

Bottom ashes collected from ESP and baghouse of seven pulverized coal-fired power plants using subbituminous and bituminous coal and a fluidized bed combustor using crushed bituminous coal were examined for their mineralogy and elemental composition. The results presented in this paper are based on the average of three samples collected from each power plant. The mineralogy of each sample was d...

The study of undertaken for heavy metal Pb accumulation by fly ash and coal waste in Singrauli industrialised district of India, using atomic absorption spectrometry. Ashes from collected vegetables and plants leaves samples were analysed for the quality and quantity of Cr, Mn, Pb, Zn, Cu, As, Ni and Co and detectable levels of all were found. Pb distrusted the metabolic processes of living org...

Carbon particles extracted from sediments collected by box coring from southeastern Lake Michigan were compared with carbon particles extracted from oil, coal, and wood fly ash. Sediments deposited after 1900 contained coal, oil, and wood carbons; older sediments contained only wood carbon.