The laser sintering process of multi-component powder W/Cu is simulated by ANSYS software based on the factors of radiation, convection and thermal physical parameters on temperature. The laser power and scanning velocity which are the key process parameters to affect directly in sintering molding are studied in paper. The results show that when the scanning velocity is constant, the sintering ...

The microstructure evolution of Fe-17 wt. % Cr-12 wt. % Ni-2 wt. % Mo stainless steel fiber felts during the fast sintering process was investigated by the synchrotron radiation X-ray computed tomography technique. The equation of dynamics of stable inter-fiber neck growth was established for the first time based on the geometry model of sintering joints of two fibers and Kucsynski’s two-sphere...

The wear resistance of Al2O3/2.5 vol.% Ni nanocomposites sintered by a conventional route was studied under ball-on-disk dry sliding conditions and compared with the same nanocomposites but consolidated by spark plasma sintering, together with alumina obtained by the same technique and by hot pressing. The results showed an improvement of about 0.5, 1 and 2 orders of magnitude, respectively. Th...

This study investigates novel deposition techniques for the preparation of TiO2 electrodes for use in flexible dye-sensitized solar cells. These proposed new methods, namely pre-dye-coating and codeposition ultrasonic spraying, eliminate the conventional need for time-consuming processes such as dye soaking and high-temperature sintering. Power conversion efficiencies of over 4.0% were achieved...

The polycrystalline Sn added Ni-Zn ferrites were prepared using the conventional sintering method. The monophasic nature of the samples was characterized using X-rays. The elastic behavior has been measured in the temperature range 80-410oC using the composite oscillator method. The values of Young’s and shear modulus are corrected to theoretical density using the method of Mackenzie method. Th...

The need to move large volumes of highly abrasive materials, such as coal, grain, sand, and various waste products, places great demands on the piping systems through which they are conveyed. Excessive wear is a common problem, especially evident in the sections of pipe, which change the direction of flow of the abrasive material. . Due to their excellent wear characteristics, ceramic materials...

By the conventional solid state reaction method, a small amount of lithium fluoride (LiF) was used as the sintering promoter to improve the sintering and piezoelectric characteristics of (Ba0.95Ca0.05)(Ti0.93Sn0.07)O₃ (BCTS) lead-free piezoceramic sheets. Using X-ray diffraction (XRD) and a scanning electron microscope (SEM), the inferences of the crystalline and surface microstructures were ob...

A novel preparing method of polymer-coated molybdenum powder was presented. A type of multi-component polymer-coated molybdenum powder was chosen for selective laser sintering. The effect of the process parameters on the part’s characteristics is investigated. Based on our study for dynamic laser sintering process of polymer-coated molybdenum powder, its laser sintering mechanism was reported a...

More than 1.15 million cubic meters (1.5 million cubic yards) of sediment require annual removal from harbors and ports along Ohio's Lake Erie coast. Disposing of these materials into landfills depletes land resources, while open water placement of these materials deteriorates water quality. There are more than 14,000 acres of revitalizing brownfields in Cleveland, U.S., many containing up to 9...