The high frequency transformer in single-phase full-bridge DC-DC converter is prone to saturation because of the asymmetry circuit parameters. Transformer will increase power consumption, accelerate aging winding insulation, and even damage switches. In order prevent this risk, a DC bias suppression strategy presented article, main advantage that problem can be completely eliminated. firstly, m...

The conventional high-frequency phase-shifted zerovoltage-switching (ZVS) full-bridge dc/dc converter has a disadvantage, in that a circulating current flows through transformer and switching devices during the freewheeling interval. Due to this circulating current, rms current stress, conduction losses of the transformer and switching devices are increased. To alleviate this problem, this pape...

The Transformer based Z-Source inverter is an enhanced series inductance Z-Source impedance network. This proposed inverter is used to combine the main circuit and the power source. This configuration delivers a strong boost capacity to overcome the barriers of the series inductance Z-source inverter. Further, with the usage of low voltage capacitors and the transformer, the capacitor voltage s...

In this paper, an approach is proposed for accurate locating of single phase faults in transmission lines using voltage signals measured at one-end. In this method, harmonic components of the voltage signals are extracted through Discrete Fourier Transform (DFT) and are normalized by a transformation. The proposed fault locator, which is designed based on Random Forests (RF) algorithm, is train...

Effect of an addition of a cooled step-up transformer to a flux locked loop (FLL) circuit was studied to reduce indirect rf interference to HTS-dc-SQUID. First, we demonstrated that a noise level of an HTS-dcSQUID system using the FLL circuit with single room-temperature transformer could be easily degraded by radiation of rf electromagnetic wave to cables in the FLL circuit. It is thought that...

This paper presents some techniques for reduction of transformer inrush current. The equation of inrush current is obtained and then by using these methods, transformer inrush current is reduced, then after comparing the result of each method, the best choice is determined. Results which have been obtained from EMTP simulation confirm these subjects.