Increasing penetration of electric vehicles brings a set challenges for the electricity system related to its energy, power and balance adequacy. Research this topic often requires estimates charging demand in various forms feed models simulations. This paper proposes methodology simulate different driver types local energy form time series sessions. The are extracted from historical session da...

Direct electric power generation using biological functions have become a research focus due to their low cost and cleanliness. Unlike major approaches using glucose fuels or microbial fuel cells (MFCs), we present a generation method with intrinsically high energy conversion efficiency and generation with arbitrary timing using living electric organs of Torpedo (electric rays) which are serial...

In This paper describes the design and implementation of Microcontroller based High Voltage pulse electric field generator for Liquid food pasteurization. It generates a high voltage (15 kV) approximately in the frequency range from 250 Hz to 30 kHz. This high voltage applied for food pasteurization, which is placed between two electrodes.

The phenomenon of saturation of electric machines constitutes an important subject of investigation in electrical engineering. This paper presents a new modeling technique for saturation in the case of induction machines. Necessary calculations to introduce this technique in the linear flux model are presented. Computed results and experimental tests on the transients of the self-excited induct...

In modern time the demand of electric energy widely increases day by day due to the reduction of the fossil fuels like (gases, liquids, coals, oil etc.) and the other environmental issues the all of world is looking for the alternative. The solar energy is the most renewable and sustainable energy sources. This paper present Simscape based modeling and performance of the photovoltaic generator ...

I. INTRODUCTION Flywheel energy storage devices are composed of a spinning composite disk in an low-pressure enclosure designed to contain the debris in the case of operation failure [18]. An electric motor-generator connector is used to convert the electric energy to kinetic energy by applying a torque on the flywheel. The torque can be positive (charge) or negative (discharge). The flywheel l...

Transient multiphysics simulations are performed to investigate the thermal and electric performance of a thermoelectric generator (TEG) module placed between hot and cold blocks. Effects of heat radiation, thermal and electric contact on the TEG are examined and the simulated results are compared with experimental data. The predicted temperature difference across the TEG module and the electri...