This article investigates the effect of contact ageing on fretting damage of an epoxy-based cathodic electro-deposited coating for use on automotive seat slide tracks (made of cold-rolled high strength steel). Static normal load was induced at the contact between the coating and an AISI52100 ball for a certain duration. It was identified that plastically deformed contact area increased logarith...

A model that predicts the static friction for elastic-plastic contact of rough surfaces is presented. The model incorporates the results of accurate finite element analyses for the elastic-plastic contact, adhesion and sliding inception of a single asperity in a statistical representation of surface roughness. The model shows strong effect of the external force and nominal contact area on the s...

This paper investigates the friction coefficient of a moving liquid marble, a small liquid droplet coated with hydrophobic powder and floating on another liquid surface. A floating marble can easily move across water surface due to the low friction, allowing for the transport of aqueous solutions with minimal energy input. However, the motion of a floating marble has yet to be systematically ch...

Time-stepping methods using impulse-velocity approaches are guaranteed to have a solution for any friction coefficient, but they may have nonconvex solution sets. We present an example of a configuration with a nonconvex solution set for any nonzero value of the friction coefficient. We construct an iterative algorithm that solves convex subproblems and that is guaranteed, for sufficiently smal...

We study theoretically and numerically the kinetics of the coefficient of friction of an elastomer due to abrupt changes of sliding velocity. Numerical simulations reveal the same qualitative behavior which has been observed experimentally on different classes of materials: the coefficient of friction first jumps and then relaxes to a new stationary value. The elastomer is modeled as a simple K...

Original scientific paper In this paper, the orthogonal cutting force model is proposed comprising forces due to flank wear in addition to the forces for chip formation during the hard turning of round bar made of steel 60WCrV7 hardened at 55+2HRc. Cutting force model includes two tool conditions: perfectly sharp tool with VBB = 0 and tool with maximum permissible flank wear VBBmax. Based on cu...

The frictional behaviors of fullerenes C60 and C70 were studied because they were speculated to be solid lubricants. For the sublimated pure C60 films on Si(001), a high friction coefficient (0.55–0.8) was observed under different loads and pin materials. For the C70 film, the friction coefficient showed a pin dependence, which changed from 0.5 with an Al2O3 pin to about 0.9 with a 440 stainles...

superplastic forming (spf) is a manufacturing process utilized in the automotive industry to produce complex geometry aluminum or magnesium alloy components which cannot be fabricated at room temperature. this paper investigates the effects of the die entry radius and the interfacial friction coefficient on the required forming time and thickness distribution of a superplastic formed part. a co...

the incremental sheet metal forming (ismf) process is a new and flexible method that is well suited for small batch production or prototyping. this paper studies the use of the finite element method in the incremental forming process of aa1050 sheets to investigate the influence of tool diameter, vertical step size, and friction coefficient on forming force, spring-back, and thickness distribut...

Solid particles on the floor, both dry and wet, are common but their effects on the friction on the floor were seldom discussed in the literature. In this study, friction measurements were conducted to test the effects of particle size of solid contaminants on the friction coefficient on the floor under footwear, floor, and surface conditions. The results supported the hypothesis that particle ...