Pool boiling experiments were conducted in microgravity on five space shuttle flights, using a flat plate heater consisting of a semitransparent thin gold film deposited on a quartz substrate that also acted as a resistance thermometer. The test fluid was R-113, and the vapor bubble behavior at the heater surface was photographed from beneath as well as from the side. Each flight consisted of a...

The forces governing flow boiling, aside from system pressure, are buoyancy, liquid momentum, interfacial surface tensions, and liquid viscosity. Guidance for approximating certain aspects of the flow boiling process in microgravity can be obtained in Earth gravity research by the imposition of a liquid velocity parallel to a flat heater surface in the inverted position, horizontal, or nearly h...

This research deals w ith simulation and experimentation of closed loop controlled class-D inverter fed induction heater system. This converter has reduced switching losses, stress and increased power density. The inverter system is designed and the simulation is done using Matlab. The results of simulation and experimentation are presented. The induction heater system uses embedded controller ...

Mitochondria from the muscle-derived thermogenic (heater) organ and oxidative red muscle of the blue marlin (Makaira nigricans) were studied in order to evaluate aspects of the mechanism of thermogenesis in heater tissue. We investigated whether short-term Ca(2+)-induced uncoupling of mitochondria contributes to the thermogenic cycle of the heater organ by enhancing the respiration rate. Specif...

This paper concentrates on the Balance-Based Adaptive Control (B-BAC) methodology and on its application to the control of the electric flow heater. The B-BAC methodology is dedicated for the control of a wide range of biochemical and heat exchange processes and the final form of the control law results from the general and simplified firstorder model of a process, in which all unknown nonlinea...

The use of an artificial roughness on a surface of absorber plate is an effective technique to enhance the rate of heat transfer to fluid flow in the duct of a solar air heater. This paper presents a comparison of parameters that enhance the heat transfer coefficient thus efficiency ofa solar air heater for different artificially roughened geometries for the Reynolds number from 2500 -18000. Th...

Abstract: The improvement of device performance of a recycling solar air heater featuring a wire mesh packing was investigated experimentally and theoretically. The application of the wire mesh packing and recycle-effect concept to the present study were proposed aiming to strengthen the convective heat-transfer coefficient due to increased turbulence. Comparisons were made among different desi...

We report a novel boiling heat transfer (NBHT) in reduced graphene oxide (RGO) suspended in water (RGO colloid) near critical heat flux (CHF), which is traditionally the dangerous limitation of nucleate boiling heat transfer because of heater failure. When the heat flux reaches the maximum value (CHF) in RGO colloid pool boiling, the wall temperature increases gradually and slowly with an almos...

Solar energy is a good option among renewable energy resources due to its easy availability and abundance. The simplest and most efficient way to utilize solar energy is to convert it into thermal energy and this can be done with the help of solar collectors. The thermal performance of such collectors is poor due to less heat transfer from the collector surface to air. In this work, experimenta...

Investigations for the melt growth gallium-antimonide (GaSb) semiconductor crystals are underway at the US Air Force Research Laboratory at Hanscom Air Force Base by the vertical gradient freeze (VGF) method utilizing a submerged heater. Electromagnetic stirring can be induced in the gallium-antimonide melt just above the crystal growth interface by applying a weak radial electric current in th...