This paper presents the small-signal operation of a $g_{\mathrm {m}}$ -boosted inverter-cascode transimpedance amplifier which has not been reported previously and whose comprehensive analysis is available in any article or text-book. A simplified sequential equivalent-circuit method employed eliminates need for complicated circuit techniques. The shows that gain gain-bandwidth transimpedance-a...

A 50 to 550MHz wideband gallium nitride (GaN) HEMT power amplifier with over 43 dBm output power and 63% drain efficiency has been successfully developed. The demonstrated wideband power amplifier utilizes two GaN HEMTs and operates in a push-pull voltage mode Class D (VMCD). The design is based on a large signal simulation to optimize the power amplifier’s output power and efficiency. To assur...

This paper presents the design of a 2-16 GHz ultra wide band low noise amplifier (UWB LNA). The proposed LNA has a gain of 11.5 ± 0.85 dB with NF less than 2.82 dB. Good input and output impedance matching, good isolation and linearity are achieved over the operating frequency band. The proposed UWB LNA consumes 18.14 mW of power from 1.8V supply. This UWB LNA is designed and simulated in 0.18 ...

We demonstrate low-voltage germanium waveguide avalanche photodetectors (APDs) with a gain × bandwidth product above 100GHz. A photonic receiver based on such a Ge APD, including a 0.13μm SiGe BiCMOS low-noise trans-impedance amplifier and a limiting amplifier, is realized. A 5.8dB sensitivity improvement is demonstrated at -5.9V bias at an avalanche gain of 6 through bit error ratio measuremen...

A highly linear programmable-gain amplifier (PGA) is fabricated using a 0.35m CMOS technology. High linearity and constant wide bandwidth are achieved by using a high-gain amplifier with low input impedance and resistor-network feedback. The voltage gain is varied by digitally controlling the input switched resistors. The distortion of a switched resistor has been analyzed using the Volterra se...

The general utility of the operational amplifier is derived from the fact that it is intended for use in a feedback loop whose feedback properties determine the feed-forward characteristics of the amplifier and loop combination. To suit it for this usage, the ideal operational amplifier would have infinite input impedance, zero output impedance, infinite gain and an openloop 3 dB point at infin...

A novel power hardware-in-the-loop interface algorithm, the Virtual Shifting Impedance, is developed, validated and demonstrated in this paper. Building on existing algorithms, method involves shifting a part of software impedance to hardware side improve stability accuracy setups. However, compared approaches, realized by modifying command signals amplifier controller, thus avoiding requiremen...

This paper discusses the use of temperature as a test observable for analogue circuits, presenting a generic configuration for analogue circuit thermal testing. As a case study, static temperature analysis is performed over a two-stage operational amplifier in view of extracting temperature waveforms at different locations on the circuit under test, both under fault-free conditions as well as i...

Recently, spiral inductors have widely been used in the design of matching circuits of a wireless transceiver. However, such elements usually have low quality factor (Q) and may encounter the self-resonance in microwave-frequency band which permits its use in higher frequencies, and on the other hand, they occupy the large on-chip space. This paper presents a new design theory for the impedance...