The purpose of this study was to investigate the effects of head hair on thermoregulatory responses when cooling the head under heat stress. Eight young males participated in six experimental conditions: normal hair (100-130 mm length) and cropped hair (5 mm length) with three water inlet temperatures of 10, 15, and 20°C. The head and neck of subjects were cooled by a liquid perfused hood while...

An experimental study was carried out to investigate the effects of inlet pressure, sample thickness, initial sample temperature, and temperature sensor location on the surface heat flux, surface temperature, and surface ultrafast cooling rate using stainless steel samples of diameter 27 mm and thickness (mm) 8.5, 13, 17.5, and 22, respectively. Inlet pressure was varied from 0.2 MPa to 1.8 MPa...

In this paper, mini-channel type evaporator which is new in mobile air conditioning (MAC) or automotive air conditioning (AAC) systems is thermally modeled. The performance of mini-channel evaporator is also compared with the laminated evaporator which is being currently used in automotive industries. The mini-channel evaporator was constructed of two rows of parallel flow mini-channel tubes...

This study aims to optimize extraction and drying conditions of fig syrup. Drying was done in a pilot scale two-fluid nozzle spray dryer. A total of 27 experiments were conducted with varying inlet air temperatures, air flow rates, and also a maltodextrin (MD)- low methoxyl pectin (LMP) ratios. While feed rate, feed temperature, and compressed air flow rate of the atomizer were kept constant. T...

A rise in inlet air temperature may lower the rate of heat dissipation from air cooled computing servers. This introduces a thermal stress to these servers. As a result, the poorly cooled active servers will start conducting heat to the neighboring servers and giving rise to hotspot regions of thermal stress, inside the data center. As a result, the physical hardware of these servers may fail, ...

Due to the direct utilization of thermal energy and possibility of using renewable energy resources, the interest of using desiccant wheels for air-conditioning application is increasing rapidly. The thermally driven desiccant cooling systems are environmental friendly and has a great potential to reduce the peak electricity demand. During the experiments the inlet and outlet parameters in the ...

Film cooling technique has been successfully applied to gas turbine blades to prevent it from the hot flue gas. However, a continuous demand of increasing the turbine inlet temperature to raise the efficiency of the turbine requires continuous improvement in film cooling effectiveness. The concept of injecting mist (tiny water droplets) into the cooling fluid has been proven under laboratory co...

This paper reports a Joule-Thomson cooling system that provides 0.1-1 W cooling power using a micromachined Si/glass perforated plate heat exchanger. The gas expansion is performed through a micromachined valve that is piezoelectrically actuated, or alternatively through a commercial jewel orifice. The modulated J-T system using the microvalve can achieve 254.5 K at a pressure difference of 430...

Selection of spiral capillary tube for refrigeration appliances and the effect of changes in the parameters such as capillary tube dimensions i.e. capillary tube diameter, coil pitch, capillary tube length and inlet conditions of refrigerant to the capillary tube i.e. degree of subcooling, inlet pressure on the mass flow rate of the refrigerant, also investigation about the coiling effect of sp...

An experimental study for air-side thennal-hydraulic performance of brazed aluminum heat exchangers under dehumidifYing conditions has been performed. For 30 samples of louvered fin heat exchangers with different geometrical parameters, the heat transfer and pressure drop characteristics for wet surface were evaluated. The test was conducted for air-side Reynolds number in the range of 80-300 a...