nowadays, we live in a world which quality, speed, accuracy and cost are the most important parameters in parts' design and manufacturing. due to the complexity of part manufacturing, traditional and nontraditional manufacturing techniques are used. aerodynamic tests usually requires one or several models for testing in wind tunnels and these models typically have particular complexities in whi...

As part of the Army's Demo III project, a sensor-based system has been developed to identify roads and to enable a mobile robot to drive along them. A ladar sensor, which produces range images, and a color camera are used in conjunction to locate the road surface and its boundaries. Sensing is used to constantly update an internal world model of the road surface. The world model is used to pred...

Waste fibers produced from manufacturing processes are a byproduct commonly deposited in storing yards and/or landfills and thus results in many serious environmental problems in Iran. If these waste materials could be advantageously put to practical use in any application, it would reduce the burden on the environment and landfills. This paper compares the performance of the stone matrix aspha...

Hyperspectral data has remarkable capabilities for automatic identification and mapping of urban surface materials because of its high spectral resolution. It includes a wealth of information which facilitates an understanding of the ground material properties. For identification of road surface materials, information about their relation to hyperspectral sensor measurements is needed. In this ...

cavernous hemangioma is a rare benign tumor of the internal auditory canal (iac) of which fourteen cases have been reported so far. tinnitus and progressive sensorineural hearing loss (snhl) are the chief complaints of the patients. audiological and radiological planes, ctscan, and magnetic resonance image (mri) studies are helpful in diagnosis. the only choice of treatment is surgery with elec...

A two fluid model (TFM) was used to study gas-solid heat transfer in a riser with different inclination angles. A two dimensional pipe with 5.8 cm internal diameter and 5 meter length was chosen.  Effect of bed angle and solid particles feed rate were studied on the heat transfer behavior of gas and solid particles. Obtained results from simulation are compared with the experimental data in the...

The author addresses the Edge Unfolding Problem, the task of determining whether a given polyhedral mesh may be cut at its edges and developed into a planar polyhedral net. It is shown that simplyconnected surfaces of negative interior curvature cannot be developed. An example is then given of a surface of negative interior curvature with two boundary loops, isomorphic to a cylinder, which is d...