A realistic non-spherical model for bubble formation in a co-flowing liquid is presented. In the model, an interfacial element approach is applied to describe the dynamics of bubble formation. The effect of flowing liquid velocity is modeled by a combination of the bubble axis translation and liquid pressure analysis of each interfacial element. The bubble shapes during formation are predicted ...

Cavitation and turbulence in a diesel injector nozzle has a great effect on the development and primary breakup of spray. However, the mechanism of the cavitation flow inside the nozzle and its influence on spray characteristics have not been clearly known yet because of the internal nozzle flow complexities. In this paper, a comprehensive numerical simulation is carried out to study the intern...

air pollution is one of the major issues about the diesel engines in todays' world. it is a special concern in those areas that have difficulty meeting health-based outdoor air quality standards. natural gas has low emission and resource abundance and also conventional compression ignition engine can be easily converted to a dual fuel mode to use natural gas as main fuel and diesel as pilo...

This paper discusses the design and development of moderate and intense low oxygen dilution (MILD) combustion burners, including details of the computational fluid dynamics process, step-by-step from designing the model until post-processing. A 40 mm diameter bluff-body burner was used as the flame stabilizer. The fuel nozzle was placed in the center with a diameter of 1mm and an annular air no...

Removal of nanometer-sized contaminant particles (CPs) from substrates is essential in successful fabrication of nanoscale devices. The particle beam technique that uses nanometer-sized bullet particles (BPs) moving at supersonic velocity was improved by operating it at room temperature to achieve higher velocity and size uniformity of BPs and was successfully used to remove CPs as small as 10 ...

Zinc sulphide thin films have been deposited with CADT using zinc chloride and zinc acetylacetonate as Zn compounds and thiourea and 1,1,3,3-tetramethylthiourea as S compounds soluted in methanol, ethanol, isopropanol and cellosolve. After optimalization of the deposition process homogeneous layers with a c-axis oriented hexagonal columnar structure with a high density (up to 96%) were obtained...

Rocket plume temperature distribution plays an important role on the heat transfer analysis of launch carriers. Thus, a non-intrusive IR scanner is used in this paper to analyze the influence of spin motion on plume centerline temperature measurements of spinning solid-propellant rockets. Results show that the average error of temperature measurement is below 3.5% even with a 10% error of estim...

A bubbly flow in a vertical miniature tube is analyzed theoretically. The liquid and gas phase are co-current flowing upward. The gas phase is injected via a nozzle whose inner diameter is 0.11mm and it is placed on the axis of the tube. A force balance is applied on the bubble at its detachment. The set of governing equations are solved by use of Mathematica software. The bubble diameter and t...

Fluid flow in the mold region of the continuous slab caster at Panzhihua Steel is investigated with 0.6-scale water model experiments, industrial measurements, and numerical simulations. In the water model, multiphase fluid flow in the submerged entry nozzle (SEN) and the mold with gas injection is investigated. Top surface level fluctuations, pressure at the jet impingement point, and the flow...