Animal viruses (e.g., lentiviruses and herpesviruses) use transcriptional positive feedback (i.e., transactivation) to regulate their gene expression. But positive-feedback circuits are inherently unstable when turned off, which presents a particular dilemma for latent viruses that lack transcriptional repressor motifs. Here we show that a dissipative feedback resistor, composed of enzymatic in...

There have been many investigations of the mutual synchronization of oscillators. In this study we consider N oscillators which have the same natural frequency, mutually coupled by one negative resistor. In this system, according to the negative range of the coupling negative resistor, we can observe various interesting synchronization phenomena. Because this system tends to minimize the power ...

Availability is one of the most frequently specified quality attributes for computerized systems and the computation of availability requires knowledge about the reliability of the system. Although much research has been devoted to software system reliability, much work remains to be done in identifying ways to predict reliability of assemblies of components. We are designing an experiment for ...

Abstract— In this study, synchronization phenomena observed in van der Pol oscillators coupled by a fifth-power nonlinear resistor are investigated. By carrying out computer simulations, interesting synchronization phenomena can be confirmed to be generated in this system. Namely, the synchronization states change according to the coupling strength and nonlinearity of the coupling resistor.

This study is the first to demonstrate characteristics optimization of nanowire resistance load inverter. Noise margins and inflection voltage of transfer characteristics are used as limiting factors in this optimization. Results indicate that optimization depends on resistance value. Increasing of load resistor tends to increasing in noise margins until saturation point, increasing load resist...

This article presents a simplified model for studying the main parameters for magnetically plucking piezoelectric beams in energy harvesting devices. The advantage of magnetic plucking is that there is no impact on the brittle piezo material. However, achieving a good release of the piezo beam is more difficult than with fingers or plectra. The influence of different magnet arrangements, the ga...

Typical holding force of piezo motors is defined by friction force, required to make motor move. However, increase of friction force is not inconsequent for motor performances in terms of speed, max motion force and lifetime (tribology). In this paper, a new motor, offering high resolution positioning and holding position when unpowered, is presented. Based on a Stepping Piezo Actuator [1] at i...

The effect of the polymeric reticulation on the thermal stability of the piezoelectricity of a micro-structured PDMS piezo-electret was investigated. This new family of flexible piezoelectric materials with very low Young’s modulus is used for wearable sensors and energy harvester devices. The best thermal stability was obtained for the piezo-electret material made from the ratio 1:10 between t...