As discussed in Part I, the type of curing light and curing mode impact the polymerization kinetics of resin-based composite (RBC) materials. Major changes in light-curing units and curing modes have occurred. The type of curing light and mode employed affects the polymerization shrinkage and associated stresses, microhardness, depth of cure, degree of conversion, and color change of RBCs. Thes...

OBJECTIVES The aim of the study was to develop a new kinetic model for the shrinkage-strain rates of dental resin composites. The effect of filler content on the shrinkage-strain kinetics and degree of conversion of dental composites was also investigated. METHODS A resin matrix containing 65 wt.% Bis-GMA and 35 wt.% TEGDMA was prepared. 0.5 wt.% camphorquinone and 0.5 wt.% dimethyl aminoethy...

This study investigated the effect of adding bioactive glass 45S5 (BG) different particle sizes to dental composite on resin polymerization and shrinkage stress formation. Commercial flowable was mixed with either 15 wt% BG fillers (nanometric, micrometric, or hybrid BG) inert barium glass. Real-time linear were recorded, degree conversion measured using FTIR spectroscopy. The commercial (unmod...

The adsorption of polymethylmethacrylate polymer of different molecular weight at the aerosil/ethyleneglycolor 1,3 butanediol-dimethacrylate interfaces was determined to provide microstructured networks. Their structural characteristics were determined to be controlled by the amount of polymer initially supplied to the system. The sediment (the settled phase) characteristics, determined as a fu...

Decalcification of cement paste in concrete is associated with several modes of chemical degradation including leaching, carbonation and sulfate attack. The primary aim of the current study was to investigate the effects of decalcification under saturated conditions on the dimensional stability of cement paste. Thin (0.8 mm) specimens of tricalcium silicate (C3S) paste, white portland cement (W...

OBJECTIVES To investigate the influence of pre-heating of high-viscosity bulk-fill composite materials on their degree of conversion and shrinkage force formation. METHODS Four bulk-fill composite materials (Tetric EvoCeram Bulk Fill-TECBF, x-tra fil-XF, QuixFil-QF, SonicFill-SF) and one conventional nano-hybrid resin composite (Tetric EvoCeram-TEC) were used. The test materials were either k...

Objective:
 To compare and characterise commercial control composites. By characterising these composites, target properties for new experimental dental composites can be outlined.
 Materials Methods:
 Three commercial, two were compared investigated. The composition of materials provided from published literature manufacturer’s information. changes in intensity spectral peaks th...