submersible water pump Shiv Lal, Pawan Kumar, Rajeev Rajora Department of Mechanical Engineering, Rajasthan Technical University Kota, India Email:[email protected] Abstract: The performance of a photovoltaic (PV) array based water pumping system situated at Kota Rajasthan (25.18 N and 75.83 E), India has been studied. A 2hp DC motor with 2200W (10 panels of each 225W) have been used for disch...

Ground faults in photovoltaic (PV) systems pose a fire and shock hazard. To mitigate these risks, AC-isolated, DC grounded PV systems in the United States use Ground Fault Protection Devices (GFPDs), e.g., fuses, to de-energize the PV system when there is a ground fault. Recently the effectiveness of these protection devices has come under question because multiple fires have started when groun...

This paper proposes accurate partial shading modeling of photovoltaic (PV) system. The main contribution of this work is the utilization of the two-diode model to represent the PV cell. This model requires only four parameters and known to have better accuracy at low irradiance level, allowing for more accurate prediction of PV system performance during partial shading condition. The proposed m...

This paper proposes a novel single-stage buck-boost three-Level neutral-point-clamped (NPC) inverter with two independent dc sources coupled for the grid-tied photovoltaic (PV) application, which can effectively solve the unbalanced operational conditions generally appeared between two coupled independent PV sources induced by the unequal irradiation and temperature distribution. The proposed c...

We have obtained high-resolution position-velocity (PV) diagrams along the major axes of the central regions of nearby galaxies in the CO-line emission using the Nobeyama 45-m telescope and the Millimeter Array. Nuclear rotation curves for 14 galaxies have been derived based on the PV diagrams using the envelope-tracing method. The nuclear rotation curves for most of the galaxies show a steep r...

The optimal location and orientation of a photovoltaic array is not sufficient to produce the maximum energy generation. The shadows are responsible for power losses. These can be reduced by the following: changing the type of PV cell used, the configuration of the bypass diodes, and also the dimension or the limits of adjustment in the MPP inverter search. In this paper, different scenarios ha...

The partial shading effect (PSE) is responsible for most power losses in a photovoltaic (PV) system. By modifying the interconnections between PV modules, called array reconfiguration, it possible to improve output under conditions (PSCs). Compared research on static PSCs, impact of dynamic PSCs arrays rarely mentioned, although deserves be studied. This paper studies PSE four traditional confi...

The hybrid system composed of a Photovoltaic (PV) array and a Proton exchange membrane fuel cell (PEMFC) is considered. Two operation modes, the unit-power control (UPC) mode and the feeder-flow control (FFC) mode, can be applied to the hybrid system. Renewable energy is currently widely used. One of these resources is solar energy. The photovoltaic (PV) array normally uses a maximum power poin...

To convert solar energy more viable, the efficiency of solar array systems should be maximized. An easier approach to maximizing the efficiency of solar array systems is Maximum Power Point Tracking (MPPT). MPPT is used in photovoltaic (PV) systems to maximize the output power of photovoltaic array, irrespective of the irradiation and temperature conditions. Many conventional MPPT fails to atta...