In most of the sheet forming processes, production of the parts with minimum thickness variation and low required force is important. In this research, minimization of the sheet thinning and forming force in the hydraulic deep drawing process has been studied. Firstly, the process is simulated using the finite element method (FEM) and simulation model is verified using the experimental results....

The r-value of a sheet metal is a measure of plastic anisotropy frequently used for prediction of performance in deep-drawing. It has also gured prominently in the literature for validation of theories where the predicted angular dependence of r is compared with the measured dependence. As plastic anisotropy in sheet metals is caused mainly by the preferred orientations of grains within the pol...

Forming limit curves (FLC) of deep drawing steel sheets have been determined experimentally and calculated on the base of the material tensile properties following the Hill, Swift, Marciniak-Kuczyński and Sing-Rao methods. Only the FLC modeled from a singly linear forming limit stress curve exhibits good consistence with experimental curve. It was established that a linearized limit stress locu...

In Incremental Sheet Forming (ISF) strains can be obtained well above the Forming Limit Curve (FLC) that is applicable to common sheet forming operations like deep drawing and stretching. This paper presents an overview of mechanisms that have been suggested to explain the enhanced formability. The difference between fracture limit and necking limit in sheet metal forming is discussed. The neck...