Enzymatic mild acidolysis lignins (EMAL) isolated from different species of softwood and Eucalyptus globulus were submitted to comparative analysis that included thioacidolysis, derivatization followed by reductive cleavage (DFRC), and DFRC followed by quantitative (31)P NMR (DFRC/(31)P NMR). While gas chromatography (GC) was used to determine the monomer yields from both thioacidolysis and DFR...

The acoustical properties of wood for instruments have mostly been studied on a few archetypal woods in Western musical instruments. The objective of this paper is to extend knowledge on the diversity in wood properties and uses in instruments from different geo-cultural areas. A wide set of data has been collected on vibrational properties of 452 species, through experiments and literature sur...

Current research and development in cellulosic ethanol production has been focused mainly on agricultural residues and dedicated energy crops such as corn stover and switchgrass; however, woody biomass remains a very important feedstock for ethanol production. The precise composition of hemicellulose in the wood is strongly dependent on the plant species, therefore different types of enzymes ar...

Of the recently developed univariate and multivariate near-IR FT-Raman methods for estimating cellulose crystallinity, the former method was applied to a variety of lignocelluloses: softwoods, hardwoods, wood pulps, and agricultural residues/fibers. The effect of autofluorescence on the crystallinity estimation was minimized by solvent extraction or chemical treatment or both. Additionally, whe...

A plan has been put forth to strategically thin northern California forests to reduce fire danger and improve forest health. The resulting biomass residue, instead of being open burned, can be converted into ethanol that can be used as a fuel oxygenate or an octane enhancer. Economic potential for a biomass-to-ethanol facility using this softwood biomass was evaluated for two cases: stand-alone...

The fuel properties of wood can be summarized by ultimate and proximate analysis and determination of the high heating value. It is not valid to list these values for species since a species has not been adequately sampled and tested. Enough is known, however, to say that softwoods have a high heating value of about 9,000 Btu per pound; whereas hardwoods have a value of about 8,600 Btu per poun...

A series of source tests was conducted to determine the chemical composition of fine particle emissions from the fireplace combustion of six species of woods grown in the northeastern United States: red maple, northern red oak, paper birch, eastern white pine, eastern hemlock, and balsam fir. Results include fine particle emission rates for total mass, organic and elemental carbon, ionic specie...

*Correspondence: J. Y. Zhu, Forest Products Laboratory, 1 Gifford Pinchot Dr., Madison, WI, USA e-mail: [email protected] Poplar NE222 (Populus deltoides Bartr. ex Marsh×P. nigra L.) wood chips were pretreated in a 390 L pilot-scale rotating wood-pulping digester using a dilute sulfite solution of approximately pH 1.8 at 160°C for 40 min for bioconversion to ethanol and lignosulfonate (LS). An est...

Studies on the durability and dimensional stability of a series of hardwoods and softwoods after thermal modification in vegetable oils and in steam atmospheres have been performed. Mass loss after exposure to Coniophora puteana (BAM Ebw.15) for 16 weeks was very low for European birch, European aspen, Norway spruce, and Scots pine thermally modified in a linseed oil product with preservative (...