Spontaneous bilateral mode II shear ruptures were nucleated on faults in photoelastic Homalite plates loaded in uniaxial compression. Rupture velocities were measured and the interaction between the rupture front and short fault branches was observed using high-speed digital photography. Fault branches were formed by machining slits of varying lengths that intersected the fault plane over a ran...

It is difficult to conduct cyclic tensile fatigue tests for fine ceramics because of its high brittleness, and a little eccentricity of loading axis and gripping device gives inaccurate strength data. So, a major part of cyclic fatigue tests have been carried out under bending load conditions, for the allowance of misalignment of loading axis is generous to some extent in the case of bending fa...

A new forced silking procedure has been developed that allows measurement of the low forces involved in the silking process and, subsequently, retrieval and tensile testing of the samples spun at the measured silking forces. A strong correlation between silking force and tensile behaviour of spider silk has been established. Fibres spun at high silking force--compared with the conventional yiel...

The effect of hypoxic hypertension on the remodeling process of the elastic laminae of the rat hilar pulmonary arteries (PAs) was studied by electron microscopy. Rats were exposed to hypoxia (10% O2) for periods of 0.5, 2,6,12,48,96,144, and 240 h. Changes in the structure of the PA elastic laminae were examined and analyzed with respect to changes in the PA wall tensile stress. The PA blood pr...

As micro-actuator materials, TiNi shape memory alloy thin films with substrate are used more and more in MEMS field. The residual stress in Ti-rich TiNi thin films with silicon substrate prepared by the magnetron-sputtering technique is measured by both X-ray glancing and contour method. The influence of crystallization annealing temperature and film thickness on the residual stress is tested. ...

Extraction of the material stress-strain curve from a dynamic tensile or shear experiment is not straightforward. Indeed, stress and strain are not homogeneously distributed in the specimen, and consequently no one-one relation exists between the measured elongation and strain on one hand, and the measured force and stress on the other hand. This work aims at improving the accuracy of the stres...

Poly lactic acid (PLA) is widely used for the manufacture of biodegradable stents (BDSs). It was observed and investigated that tensile loads can significantly affect the degradation rate of PLA in our previous study. Additionally, non-uniform degradation can arise from complicated stress distributions in implanted stents under long-term and pulsatile tensile loading. The objective of this work...

n the early stages of growth has been measured in α-Al2O3 (alumina) scales formed on and NiAl-based alloys during heating in air at 1000 to 1200°C. Scale thickness rom 0.5 to 5 μm, times from 5 to 720 min. Stress was measured using the multiple-tilt . In order to measure the thinnest scales at the earliest times, focused, monochromatic tron radiation was used for high intensity, and a fixed, sm...

Barium strontium titanate thin films are being developed as capacitors in dynamic random access memories. These films, grown on silicon substrates, are under tensile residual stress. By a converse electrostrictive effect, the in-plane tensile stress reduces the capacitance in the thickness direction of the film. We measured the substrate curvature change upon the removal of the film, and found ...

using cold working fastener holes is a simple life enhancement procedure that strengthens metallic components by retarding crack growth around a hole. in the present paper, the residual stress field that is induced by the hole expansion process is obtained based on different material models namely elastic perfect plastic, isotropic hardening and kinematic hardening using three-dimensional finit...