This article describes molecular dynamics simulations of an ionic liquid (IL) confined between iron oxide surfaces under relatively high pressure and severe shearing, representative of a typical steel-steel lubricated contact. The simulations reveal the presence of hydrodynamic and thermal slip at the walls, despite the wetting nature of the fluid/wall interface. A crucial consequence of the te...

The brushes are used for transmission of electric current from or to rotating surfaces depending on the type of electrical machines. Besides the process of current transmission, what is significant for the brushes is the tribological process, which is the subject of the experiment. The brush was exposed to a planned experiment and a regression and correlation analyses of tribological process of...

In order to further enhance tribological properties 316 Low carbon stainless steel (L SS) used on mechanical parts. CrN/TiN with DC magnetron sputtering sources was carried out on PVD 316 L SS. The micro structure of the CrN/TiN coatings were investigated by Scanning electron microscope (SEM), X-ray Diffraction (XRD) and tribology properties were investigated on a Pin on Disc friction and wear ...

Biomimetics is a field that has the potential to drive major technical advances. It might substantially support successful mastering of current tribological challenges, i.e., friction, adhesion and wear in machines and devices from the meter to the nanometer scale. Science currently goes through a major change, with biology gaining increasing importance. Indeed, biology is becoming the new Leit...

In this paper, the babbitting of a bearing in boiler feed pump of an electromotor has been studied. These bearings have an important role in reducing the shut down times in the pumps, compressors and turbines. The most conventional method in babbitting is casting as a melting method. The comparison between thermal spray and casting methods in babbitting shows that the thermal spraying babbitt l...

The main effect of the introduction of fluorine to diamond-like carbon (FDLC) thin films is the reduction in surface free energy (SFE). Regarding tribological properties, frequent allusions to low friction are found in the literature. However, studies proving a direct relationship between fluorine content in DLC films and macroscopic friction reduction are hard to find, while others state fluor...

UNLABELLED In this paper, metal nanodumbbells (NDs) formed by laser-induced melting of Ag nanowires (NWs) on an oxidized silicon substrate and their tribological properties are investigated. The mechanism of ND formation is proposed and illustrated with finite element method simulations. Tribological measurements consist in controllable real-time manipulation of NDs inside a scanning electron m...

Wear rate and debris are key problems to implanted metal-on-metal hip joints. Surface texture on bearing surfaces is reported to increase tribological performances. Research on the translation of this technology to metal-on-metal hip joint for reduction of friction, wear rate and debris generation is limited. The aim of this study was to investigate, by theoretical predictions and experimental ...

Arthritis is a leading cause of disability, and when nonoperative methods have failed, a prosthetic implant is a cost-effective and clinically successful treatment. Metal-on-metal replacements are an attractive implant technology, a lower-wear alternative to metal-on-polyethylene devices. Relatively little is known about how sliding occurs in these implants, except that proteins play a critical...

Physical properties of two-dimensional materials, such as graphene, black phosphorus, molybdenum disulfide (MoS2) and tungsten disulfide, exhibit significant dependence on their lattice orientations, especially for zigzag and armchair lattice orientations. Understanding of the atomic probe motion on surfaces with different orientations helps in the study of anisotropic materials. Unfortunately,...