Voltage instability is a crucial issue in the secure operation of power grids. Several methods for voltage stability assessment were presented. Some of them are highly computationally intensive, while others are reported not to work properly under all circumstances. This paper proposes a new methodology based on the generator equivalent circuit model (GECM) and the phasor measurement unit (PMU)...

The static voltage stability and the dynamic voltage stability are integrated. To consider a shunt compensator and/or a more general load which is dependent on voltage, a modified criterion for the static voltage stability is developed and the system is controlled to satisfy this static Stability criterion. For an accurate analysis of the dynamic voltage stability, the system model includes exc...

The paper presents a method for finding out the weakest bus based on reactive power sensitivity index for a multibus real system. The Voltage Stability Margin (VSM) and change in voltage has also been calculated for the verification for with and without compensation. These techniques are tested on the 400 KV WBSEB system proposed in the 9th plan and results are given to prove the effectiveness ...

This article describes the methodology for evaluation of the reliability of an composite electrical power system considering voltage stability and continuation power flow, which takes into account the peak load and steady state stability limit. The voltage stability is obtained for the probable outage of transmission lines and removal of generators along with the combined state probabilities. T...

when power systems are expanded and connected together with weak tie lines, the low-frequency oscillations are increased and the stability margin of the power system decreases. therefore, when designing the transmission system to be used, it is necessary to maintain the dynamic stability of the power system, and to make sure to have the most possible stability margin. sssc is a facts device con...

Abstract With the rapid increase of distributed photovoltaic (DPV) generations, static voltage stability (SVS) distribution network (DN) is faced with more and challenges. Considering characteristics DPV structure, an appropriate index (SVSI) in medium-voltage DN studied this paper. In terms limitation traditional SVSI that only reflects load change, based on P-V curve, a novel change rate - (M...

To address the static voltage stability issue and suppress the voltage fluctuation caused by the increasing integration of wind farms and solar photovoltaic (PV) power plants, a two-tier reactive power and voltage control strategy based on ARMA power forecasting models for wind and solar plants is proposed in this paper. Firstly, ARMA models are established to forecast the output of wind farms ...

For multi-objective optimal reactive power dispatch (MORPD), a new approach is proposed where simultaneous minimization of the active power transmission loss, the bus voltage deviation and the voltage stability index of a power system are achieved. Optimal settings of continuous and discrete control variables (e.g. generator voltages, tap positions of tap changing transformers and the number of...

The recent trends in electrical power distribution system operation and management are aimed at improving system conditions in order to render good service to the customer. The reforms in distribution sector have given major scope for employment of distributed generation (DG) resources which will boost the system performance. This paper proposes a heuristic technique for allocation of distribut...

Voltage stability analysis is needed in the planning or operation of electric power systems. This will have an impact on decreasing system voltage and result a collapse be fatal resulting partial total blackout. If there change load line, it can cause decrease profile. Predicting value additional bus based done to detect occurrence drop. There are various methods for analyzing stability, one wh...