The aim of this study was to assess the feasibility and accuracy of a novel magnetic resonance-compatible (MRc)-spirometer. The influence of body posture, magnetic resonance (MR)-setting and image acquisition on lung function was evaluated. Dynamic MR imaging (dMRI) was compared with simultaneously measured lung function. The development of the MRc-spirometer was based on a commercial spiromete...

the effects of steel wire patenting process parameters on very fine interlamellar spacing in the pearlitic steel wire were investigated and the optimized condition of the process was achieved. in this work, the initial nanopearlitic structure was obtained in a 0.72 wt% carbon steel wire before the wire drawing process. the results were the minimum interlamellar spacing of 35 nm and maximum ulti...

OBJECTIVE To compare measurements of the peak expiratory flow rate taken by the mini Wright peak flow meter and the turbine spirometer. DESIGN Pragmatic study with randomised order of use of recording instruments. Phase 1 compared a peak expiratory flow type expiration recorded by the mini Wright peak flow meter with an expiration to forced vital capacity recorded by the turbine spirometer. P...

Abdominal Functional Electrical Stimulation (AFES) has been shown to improve the respiratory function of people with tetraplegia. The effectiveness of AFES can be enhanced by using different stimulation parameters for quiet breathing and coughing. The signal from a spirometer, coupled with a facemask, has previously been used to differentiate between these breath types. In this study, the suita...

OBJECTIVES The aim of this study is to evaluate the ability and practice of spirometry, training of technicians, and spirometry features in primary care centers in Spain, evaluating those located in a rural environment against those in urban areas. METHODS An observational cross-sectional study was conducted in 2012 by a telephone survey in 970 primary health care centers in Spain. The center...

A comprehensive evaluation of 62 spirometers from 37 different sources was performed using a two-part protocol: calibrated syringe, and dynamic waveform testing. All testingwas done with ambient air. Calibrated syringe testing examined the ability of the spirometers to accurately measure the output of a 3 L calibrating syringe under varying conditions. The accuracy, FVC volume linearity, and st...

the micro wire electrical discharge machining (micro wire-edm) process is a modern machining process with various applications in manufacturing micro-parts. the recast layer remaining on the machined surfaces is an inevitable complication of this process. this layer can subsequently affect the machined parts performance. to optimize the recast layer in the micro wire-edm of the molybdenum micro...

The size and length effects of an inclusion on multi-pass copper shaped-wire drawing were investigated. For this purpose, an experimental investigation on optimal die half-angle was conducted. Based on experimental data of optimal die half-angle, wire and inclusion deformations, drawing and hydrostatic stress of copper shaped-wires that contain an inclusion were calculated by two-dimensional fi...