The fluoride release of restorative materials in deionized water has been the subject of many studies, but the behavior of these materials under conditions of acid challenge that simulates the oral cavity, needs to be further explored. Therefore, the aim of this study was to evaluate the fluoride release of restorative materials in two storage protocols: deionized water and pH-cycling system (d...

PURPOSE The purpose of this prospective and randomized in vivo study was to compare the clinical and radiographic outcomes of an adhesive resin system vs a calcium hydroxide liner for protection of the dentin-pulp complex of primary molars treated with indirect pulp treatment. METHODS Forty-eight primary molars with deep occlusal caries, but without preoperative signs and symptoms of irrevers...

Objectives: The purpose of this study was to compare microleakage of Class V restorations following acid, laser or laser and acid treatment of cavity walls. Methods: Standardized lingual and buccal Class V preparations were made in 18 human extracted third molars. The preparations were randomly assigned to three equal groups (nˆ 12). Group 1: cavities were treated with 35% phosphoric acid. Grou...

The aim of this pilot study was to evaluate the shear bond strength of superficial bovine incisor dentin in different crown regions. Bonding was performed to the incisal, middle and cervical thirds of superficial bovine coronal dentin (n = 20) with a two-step etchand-rinse adhesive (Optibond Solo Plus) and resin composite (Z100). Shear bond strength was evaluated at 24 h and failure modes of re...

Er-YAG laser irradiation has been claimed to improve the adhesive properties of dentin. We tested the hypothesis that dentin adhesion is affected by Er-YAG laser conditioning. Superficial or deep dentin from human molars was: (a) acid-etched with 35% H3PO4; (b) irradiated with an Er-YAG laser (KaVo) at 2 Hz and 180 mJ, with water-cooling; and (c) laser- and acid-etched. Single Bond (3M ESPE) an...

The aim of this study was to evaluate the influence of techniques of composite resin polymerization and insertion on microleakage and microhardness. One hundred and eighty class II cavities were prepared in bovine teeth and assigned to six groups: G1 - bulk filling + conventional polymerization; G2 - bucco-lingual increments + conventional polymerization; G3 - bulk filling + soft-start polymeri...

Micromechanical physics of critical fiber length, describing a minimum filament distance for resin impregnation and stress transfer, has not yet been applied in dental science. As a test of the hypothesis that 9-micron-diameter, 3-mm-long quartz fibers would increase mechanical strength over particulate-filled composites, photocure-resin-pre-impregnated discontinuous reinforcement was incorpora...

The aim of this study was to evaluate the shear bond strength of brackets bonded with different restorative systems and compare it with that afforded by an established orthodontic bonding system. Seventy human bicuspids were used, divided into five different groups with 14 teeth each. Whereas a specific orthodontic bonding resin (Transbond™ XT) was used in the control group, the restorative sys...

OBJECTIVES The purpose of this study was to investigate the viscoelastic properties related to the handling characteristics of composites. METHODS A custom-designed vertical oscillation rheometer (VOR) was used for the rheological measurements of composites. The VOR consists of three parts: (1) a measuring unit, (2) a deformation induction unit, and (3) a force-detecting unit. Two medium-visc...