[1] Bed load sediment particles supplied to channels by hillslopes are reduced in size by abrasion during downstream transport. The branching structure of the channel network creates a distribution of downstream travel distances to a given reach of river and thus may strongly influence the grain size distribution of the long-term bed load flux through that reach. Here we investigate this hypoth...

A formalism is developed for evaluating the momentum distribution for proton production in nuclear abrasion during heavy ion collisions using the Glauber multiple-scattering series. Several models for the onebody density matrix of nuclei are considered for performing numerical calculations. Calculations for the momentum distribution of protons in abrasion are compared with experimental data for...

The wear of cental amalgam was studied by single- and double-pass sliding and by a silicon carbide abrasion test. A dispersed amalgam showed significantly better resistance to two-body abrasion than the spherical amalgams tested. The wear amalgam was determined by resistance to penetration and by a ductile mode of surface failure over the load range studied. Differences in the wear of amalgam a...

bioactive glass air abrasion is a conservative technique to remove initial decalcified tissue and caries. this study examined the shear bond strength of composite resin to sound and decalcified enamel air-abraded by bioactive glass (bag) or alumina using etch-and-rinse and self-etch adhesives.forty-eight permanent molars were root-amputated and sectioned mesiodistally. the obtained 96 specimens...

This study explored the mechanisms by which crevices act as refugia for small algae during abrasive disturbances. Four substrates with different crevice features were subjected to three levels of abrasion in a stream-based experiment. Substrates were sand-grain caddisfly cases and three glass rod substrates that mimicked caddisfly cases in size and shape, as well as forming a gradient of larger...

This paper describes the results of room temperature joining of TiO2 / SiO2 IRF by sputter deposition with a special emphasis of improvement of adherence at the interface. This multilayer system is designed to shield the infrared energy of solar spectrum by interference reflection. The abrasion resistance of the multilayer stacks was also estimated by the Haze value after the Taber abrasion tes...

This paper describes an in-depth evaluation of an abrasion testing procedure for concrete pavers developed in Australia The test involves abrasion of the paver surface by a rapidly rotating ball race under load. Water is used both to lubricate the race and to remove debris. The investigation included the study of factors affecting the test results such as the load applied to the ball-race, the ...