A new indexing procedure based on the direct measurement of the possible grain orientation is presented to characterize single grains within the frame of three-dimensional X-ray diffraction. Depending on the number of reflections considered, the accuracy of grain orientation may be less than 0.1°. The newly developed indexing method was applied to characterize orientation changes of single grai...

one of the problems in the case of stainless steels is their low corrosion resistance against pitting corrosionin chloride containing environments, thereby leading to severe damage to industries. in this research, the pitting corrosion of 304 austenitic stainless steel was studied in 3.5% nacl solution at room temperature (25˚c) by performing electrochemical measurements (containing cyclic pola...

Plastic pre-strains were applied to the metastable 304L austenitic stainless steel at both room temperature (20 °C) and higher temperatures (i.e., 50, 80 and 100 °C), and then the hydrogen embrittlement (HE) susceptibility of the steel was evaluated by cathodically hydrogen-charging and tensile testing. The 20 °C pre-strain greatly strengthened the steel, but simultaneously significantly increa...

A series of tests were conducted using varying levels of nitrogen and helium in a conventional argon shielding gas when welding 316LN austenitic stainless steel. The outcome was that a 15 per cent nitrogen addition to the argon shielding gas had the most significant effect on increasing the weld metal nitrogen. Subsequent additions of helium to the argon 15 per cent nitrogen shielding gas had v...

iii Abstract: High manganese TWIP (TWinning Induced Plasticity) steels are particularly attractive for automotive applications because of their exceptional properties of strength combined with an excellent ductility. However, as austenitic steels, they appear to be sensitive to liquid zinc embrittlement during welding, the liquid zinc arising from the melted coating due to the high temperatures...

A generalized phase transformation kinetics model is used to understand the martensite to austenite transformation in a cold-rolled and annealed metastable AISI 301LN ultrafine-grained austenitic stainless steel. The model shows that the presence of interstitial nitrogen and heavy cold-rolling is important to promote fast transformation kinetics, through rapid nitrogen-diffusion and austenite n...

Résumé : In this paper, two methods were applied to determine the different elastics constants of the face centered cubic austenitic stainless steel Fe0.62Cr0.185Ni0.185. Firstly, the quantum mechanical simulation was applied based on the first principles calculations within the generalized gradient approximation (GGA) by using the efficient strain-stress method. Secondly an artificial neural n...

Orthodontic mechanotherapy encompasses the use of several archwires during speci c stages of treatment. Metallic orthodontic appliances consist of bands, arch wires, ligature wires, hooks, tubes, brackets, and springs are daily used in orthodontic practices for the correction of malocclusions in patients ( Oh et al. , 2004 ; Verstrynge et al. , 2006 ; Sabane et al. , 2009 ). One of the most im...

In this paper, a new technology for a novel material inherent load sensor for sheet metal components of metastable austenitic steel is presented. The new technology is based on load induced martensite formation and is investigated in the Collaborative Research Centre (CRC) 653. The sensors are small areas in the sheet metal material, which have been plastically deformed by means of stamping. Du...

To upgrade the performance of welded joints the various improvement methods are used. Shot peening is one of the improvement method used to strengthen the properties of welded joints. GMAW process is very well suited for welding of AISI 304 austenitic stainless steels. Regression analysis is the statistical modeling technique, and it is suitable for the majority of predicting problems. It is va...